Kohler Logo

Kohler Recent Questions, Troubleshooting Help & Support

Do you work here? Claim your company

  • 1K Products
  • 12K Answers

buy the kit to rebuild it and follow the instructions

Kohler FortĀ©... | Answered on Oct 07, 2017

ask your serviceman if theres a battery in the controller. if so its probably dead and that would make it lose time settings i would think.

Kohler 12 kW... | Answered on Oct 05, 2017

You will likely need to reference your instruction manual for that specific control panel.

Kohler 12 kW... | Answered on Sep 24, 2017

usually the flapper is the first thing to check, sometimes the whole assy needs to be replaced and a new flapper will not seat and keeps on leaking

Kohler Home | Answered on Sep 23, 2017

Go to the kohler web site for instructions. If nothing you can google this and probably get a utube video to show you how it is done.

Kohler... | Answered on Sep 15, 2017

did your old diverter have a shut off knob on it? if so you may have not noticed it leaking, -what causes that is the existing shower faucet may have been mounted to high from the spout below -or the pipe going down from existing fixture to the tub faucet spout pipe may not be at least 3/4", -if its 1/2" it will always do that

Kohler Home | Answered on Sep 12, 2017

If you want to solve your problem, click on the link I attach Best Manuals

Kohler... | Answered on Sep 08, 2017

replace the valve rubber at the top of the inlet control

Kohler Toilet -... | Answered on Sep 06, 2017

Try cleaning the surface of the drain hole where the flapper fits. There might be crud causing it to not seal. Sometimes the flapper itself is not large enough (or too large) to properly fit the hole. If no good you might try weighting the flapper. Not easy to do. You'll have to pull the flapper, dry it completely find the right adhesive place the weight just right. And hope that works. Good Luck...

Kohler - Toilet... | Answered on Sep 04, 2017

Does your unit have a low oil kill sensor if it does the unit won't start if the oil is low also if the sensor is bad that will kill the power. I do know if this may be your problem but check the oil level. good luck.

Kohler CH25... | Answered on Sep 03, 2017

either flapper needs replacing or water level float set to high

Kohler Home | Answered on Aug 19, 2017

not much can be done to repair it
you can try a new unit and ask for a warranty refund on the one you have

Kohler Plumbing | Answered on Aug 17, 2017

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Kohler Experts

Donni Steen

Level 3 Expert

687 Answers

Bill Boyd

Level 3 Expert

53745 Answers


Level 3 Expert

22966 Answers

Are you a Kohler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides