Kohler Logo

Kohler Answered Questions & Fixed Issues

Do you work here? Claim your company

  • 1K Products
  • 12K Answers
  • 467K Views

The engine is failing to run after a commanded start. Repeatedly.

Kohler... | Answered 16 hours ago | 13 views


Are there any faults listed on the control display? If display is dark then likely a battery issue. Check battery voltage with a Digital Multi Meter (DMM). It should be at least 12.5VDC.

Kohler... | Answered 3 days ago | 26 views


Sounds Like possibly the regulator is the issue.
Flightsystems Can test these to see if it is good or not.
also here is a link for the service manual
https://us.v-cdn.net/5020499/uploads/editor/0c/g1lx13xi2vyy.pdf

Kohler... | Answered 3 days ago | 330 views


the parts manual is a tp-5317 which I do not have . You said its a dec2? or a fast response 2? What is the part number off the main circuit board in the control box?

Kohler... | Answered 3 days ago | 59 views


if you have an scr pack, that has 6 pins, there are two for ac, two for gates, and two for the excitation field.
The two gate wires come off your adc controller.

Kohler... | Answered 3 days ago | 45 views


I don't know this specific tub, but here's the pictoral. The button (90105) should come out of its base, held by friction of O ring. This should allow you to disconnect the pressure line. If you are looking to replace the complete assembly, likely you will need a basin wrench to reach nut (65157).
kohler1-ggmuzyqdnvlyrlfigj0gxfoh-4-0.png Here are links to Kohler, specific to this tub.
https://www.us.kohler.com/us/catalog/svg_viewer.jsp?productId=415928&diagram=3 https://www.us.kohler.com/webassets/kpna/catalog/pdf/en/1010564_5.pdf

Kohler Home | Answered on Mar 18, 2019 | 40 views


you have kids??? theres probably something large in the trap

Kohler Home | Answered on Mar 10, 2019 | 32 views


call a plumber if you dont know what to do...

Kohler - Toilet... | Answered on Mar 04, 2019 | 3,298 views


Smart-a$$ answer is to find an old 3 gallon pot in a salvage place. Best answer is to fiddle with the chain that goes from the handle to the flush flapper and see if adjusting its length makes a difference. If it's too short it might result in letting the flapper closing too soon and allowing your deposit to remain.

Kohler Home | Answered on Mar 01, 2019 | 365 views


http://www.kohlerpower.com/onlinecatalog/pdf/g2058.pdf
Safety shutdowns:
  1. Loss of coolant
  2. High water temperature
  3. Low oil pressure
Likely one of these. If no indicators at a panel check at the connector.

Kohler... | Answered on Feb 19, 2019 | 47 views


Your focus indicates a sewer issue and not a drain issue.
The first challenge is to determine which branch leg of the sewer is the issue and then assess where all your access ports are. Sometimes an outside access port has been covered over by dirt/mulch etc.
If you know where the blockage is ... then as mentioned by other contributors ... you will need a snake. They can be hand driven or motor driven. For great access to the blockage you may need to remove the closest toilet, since snaking through the lower S trap of the toilet really inhibits the snake's effectiveness. Depending on how your house is built ... the roof sewer vent pipes can be a good access point (and sometimes that is where the debris has gotten into your sewer if you have overhanging trees). I have had success with running a garden house up to the roof and down through the vent pipe. You need to have a second person watching by the the toilet to make sure it does not back flow on to the floor. You can get hose spray attachments which help propel the hose and add turbulence to break the blockage ... but I have never tried them.
If your blockage is recurring over the seasons ... and if you have a number of trees close to your sewer line outside then you can have tree root intrusion into the sewer. In that case you need a professional with a special snake that actually has cutting capability to remove the roots.
Attached are 3 photos ... manual snake, motor snake, hose spray nozzle
Good luck with your troubleshooting!
capture2-bc3vgyatevd4ip5u5o1k1tox-1-0.png

capture1-bc3vgyatevd4ip5u5o1k1tox-1-2.png

capture-bc3vgyatevd4ip5u5o1k1tox-1-5.png

Kohler Model... | Answered on Jan 12, 2019 | 594 views


There's something blocking it sometimes if you turn the water off in your home and turn it back on sometimes calcium from the pipes break loose and cause blockage in new style washerless valve assemblies.

Kohler Home | Answered on Jan 11, 2019 | 54 views


Only if you don't mind having to replace the valve after you finish forcing it with pliers.

Kohler Plumbing | Answered on Jan 08, 2019 | 104 views


Get a water hose,place in tub,connect to water outlet,turn on for a minute,then turn off.then disconnect hose,then water will come out.

Kohler Home | Answered on Dec 29, 2018 | 48 views

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Kohler Experts

Donni Steen

Level 3 Expert

687 Answers

Bill Boyd

Level 3 Expert

53745 Answers

 steve
steve

Level 3 Expert

23016 Answers

Are you a Kohler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...