Printer keeps printing previous data without giving any command.

go to control panel--to add a printer--click on the printer and you will see whats printing
highlight each line in the print task que one at a time and cancel print
the command is probably in a loop and it will print the previous print instruction over until the task is deleted

Windows Server 2003/Thin N Computing thin client L300 Printer Epson FX2175 installed with thin client when dos base print command is given 1st page is printed but when 2nd print command is given printer gets offline either switch off printer before giving comman or print from printer properties. Again third page print command is taken by printer (For alternate pages print command printer gets offline automatically)

Why don't you just print the data on the one side of the page and then simply turn the page over and reinsert it into the paper feeder and then print the next bit of data, therfore you end up with both sides of the page printed without worrying about printer commands that seem to fail.

Could be of appropriate Driver Version.
Plz check with different Version depending upon ur Windows OS

I'm not an expert but this is lnk that helped me with my problem. http://h10025.www1.hp.com/ewfrf/wc/document?docname=c00304007&tmp_task=solveCategory&lc=en&dlc=en&cc...

goto control panel and click on printers or printer or faxes. when you open this folder your printer is shown double click on it and select all the previous print comands and if all comands will not removed switch off ur printer and the try again . and if the problem is same then unplug or plug ur usb data cable or if the problem can't be resolved the change ur data cable.

Here so many mistakes you are doing which is when you are select the data you are not keeping your printer in offline mode.
When you will get the data from your laptop don't connect with the printer .
After the data is ready to give the printer then connect with printer and print your data.

Dear sir,
install new oparating system and attach data cable in your pc then show a new hardware .
This printer is auto plug &play not driver requarments.If you are not success then change data cable with new one.
Thanks

trash and re-install the drivers

Hai,
before giving the print command clear the previous notepad given by the printer by manul and restrat your printer and give print command