Hotpoint Aquarius WD640 Front Load Washer/Dryer - Page 2 - Answered Questions & Fixed issues
How do I control the temp of wash
make sure the hoses,s r in the rite place or remove the hot hose and let it heat the water from cold if that dosent fix it the thermostat my b faulty
2/14/2015 1:08:15 PM •
Hotpoint...
•
Answered
on Feb 14, 2015
•
82 views
Why wont washer door open
Hi.
The most common reason for your problem is because the door interlock is faulty.
The interlock (see below) is what prevents the door from opening during operation
It probably needs to be replaced.
Good luck.
Nomess
1/13/2015 5:26:40 PM •
Hotpoint...
•
Answered
on Jan 13, 2015
•
58 views
Door catch stopped working
Hi
It Sounds like the Interlock needs to be replaced.
Not difficult for a serviceman, but not advised for handyman.
Good luck.
Nomess
1/13/2015 5:05:25 PM •
Hotpoint...
•
Answered
on Jan 13, 2015
•
56 views
With flashing light f 12
F12s low water pressure, normally either te taps stuck or the fill hose is kinked/blocked
12/28/2014 4:22:28 PM •
Hotpoint...
•
Answered
on Dec 28, 2014
•
78 views
We have F-13 flashing. Can you please advise what
Error code F13 indicaters dryer fan or dryer thermistor faulty.
These are to be be found in the top of the washer on top of the heater manifold.
To access them remove top cover.
Please rate my solution.
Thankyou.
12/23/2014 5:25:25 PM •
Hotpoint...
•
Answered
on Dec 23, 2014
•
644 views
Condensed dryer keeps tripping out my electric when I turn it on
Disconnect from mains. Remove rear panel and water will probably come out. This water is being flung by the fan onto the heater hence tripping the electric.
cause of water being here is a blockage in the condenser stopping flow into water chamber or possibly but unlikely, failure of the pump
11/25/2014 11:48:55 PM •
Hotpoint...
•
Answered
on Nov 25, 2014
•
197 views
Bypass the timer switch
Fit new timer switch to avoid heating if you bypass it it will go flat out and burn out the element.
11/15/2014 9:49:49 PM •
Hotpoint...
•
Answered
on Nov 15, 2014
•
929 views
Hi i have a Hotpoint WD640 1400 spin Aquarius +
The dryer fan or dryer thermistor (thermostat) is faulty.
If the fan is working, then replace the thermistor, or check for broken wire.
Please rate my solution.
Thanks.
11/15/2014 10:12:33 PM •
Hotpoint...
•
Answered
on Nov 15, 2014
•
899 views
Not drying
Is it still under warranty? I've read that these machines are better left at the retailer...
11/15/2014 9:17:38 PM •
Hotpoint...
•
Answered
on Nov 15, 2014
•
864 views
Not finding what you are looking for?