Washing Machines - Recent Questions, Troubleshooting & Support
Gorenje washing, why does it stop with 1 left ?
Your NOT suppose to "Program anything". Machines are kinda like people. After they work, they need "some" time to rest. Your machine (And Mine) all do this. Next time leave it alone, the minute will count down and it will automatically shut off. Question? You actually stood by the machine and watched the entire cycle? Was there another problem that motivated you to do this? Like your clothes were still wet or water still in the tub? If you need further help, reach me via phone at
https://www.6ya.com/expert/steven_b77d19396bfe2249
I want to bypass lid lock
It would be innapropriate to recomend the removal of a safety device.
I would repair it, not remove it.
Why does my water won't stop filling?
A few possible causes:
Blocked Water Level Switch: Most top-loading washing machines utilize a pressure switch to tell the water when to shut off during a wash or rinse cycle. If the tube becomes blocked with minerals from hard water or if the switch itself goes bad, the water will never shut off.
Bad Water Valve: Valves at the points where the hot and cold water hoses enter your washing machine control the flow of water into the machine. If these valves become stuck open, or if their seals become lost or compromised, the water will continue to flow into the machine.
Faulty Controls: The controls might fail to acknowledge the input from the pressure switch and never advance from one cycle to another. In some cases, this is a voltage problem, while in other cases the controls themselves are bad and would need to be replaced.
If you've already cleaned and cut the ends of the tube going to the level sensor and the issue persists, it might be best to consult with a professional appliance repair service. They can help diagnose and fix the problem accurately. Please remember to turn off the water supply and unplug the machine before attempting any repairs.
Error code in JCB 437 loader Q0195 any have a clue?
on a loader its most often fluids or leaky compresion
masters or slaves or the distribution
and or it need bleed or and filled etc {not easy}
you need a tech it needs a fluids check
could be just a bad filter...
Replace lid switch on kenmore washing machine top load model #110.24962301
Thats a simple one to replace. Unplug unit. Take a putty knife and release clips that secure console to top. They are located on each front corner of console. Raise lid. Unplug harness from switch. Take ground screw out that is part of switch assembly. Release plastic tab that holds switch in place and remove switch. Install and snap into place new switch with lid open. Put ground screw back in place and plug harness back into place. Lower lid and then raise and listen for clicking noise. Put console back in place. That’s it.
What year is my Elite 1778t 611379 thank you
The Elite T Series guitars were made in the USA and are known for their exceptional sound engineering and craftsmanship.
Unfortunately, the exact manufacturing year based solely on the serial number is not provided in the available information.
OVATION GUITARS
My washer is top lip, now the washer stop spinning. How to fix it please?
'top lip'? you mean a top load?
If it washes okay and the motor runs, it is likely the capacitor on the motor that does spin has failed,
Or the motor control board has failed.
Or the timer controller / main board has failed.
FULL 'make model (what it is)' in all questions please, first 3 words
Not finding what you are looking for?