Kohler Popular Questions, Answers, Tips & Manuals

-Only at the sink has no hot water...? If yes then: -Make sure the valve on the wall is Turn On. -If not sure which way then turn faucet on and then turn the vale on to either side to find out. Good luck Mai

Please resubmit so you can be understood.

Go to the kohler web site for instructions. If nothing you can google this and probably get a utube video to show you how it is done.

just turn the water valve down some

Never heard of such a thing. You'd better contact Kohler on this one, bro. . .

They should be able to help you . They have a website you can use to find parts you needed. As do other d i y stores.

Its only supposed to start in neutral

If you want to solve your problem, click on the link I attach Best Manuals

usually the flapper is the first thing to check, sometimes the whole assy needs to be replaced and a new flapper will not seat and keeps on leaking

not much can be done to repair it you can try a new unit and ask for a warranty refund on the one you have

replace the valve rubber at the top of the inlet control

yes there is an o-ring to prevent leaking

Fault code is displayed if the engine starting battery voltage rises above 16 VDC for a 12 VDC system or above 30 VDC for a 24 VDC system for more than 2 seconds when the engine is not running. This fault condition does not inhibit engine starting. The fault condition clears when the battery voltage returns to a voltage within the limits for more than 2 seconds Check the battery rating and condition.

usually means you have to replace the carb and get the gasket with it. when the needle valve develops a problem they don't intend for you to fix it. this has been my experience.

Does your unit have a low oil kill sensor if it does the unit won't start if the oil is low also if the sensor is bad that will kill the power. I do know if this may be your problem but check the oil level. good luck.

you can try to remove it or you can go to a plumber supply shop and get a new level controller faster easier and gives another 10 years of service you may have to remove the unit from the cistern to get enough force applied to turn the cap so the job is half done anyway

check diodes on main control board. they short out if something went wrong.

either flapper needs replacing or water level float set to high

If your mower runs fine, but dies when the blades are engaged, that has nothing at all to do with the starter - or with the engine. There is a malfunction is in either the electrical system, PTO clutch or one of the safety features somewhere. Check all of the belts first for wear or breakage, then if they're OK, you probably need a small engine mechanic, but it doesn't sound really serious.

Check your owner's manual