How to remove burnt grease, fix lightly scratched black stovetop?

There is this white stuff sold for glass-top stoves. I presume it is good old iron cleaner, a very mild cleaner/polish. Also consider toothpaste.

There is a product called cerama bright (Not sure of the spelling). Specifically formulated for exactly this type of cleaning. Availible through just about anywhere (Home Depot, Lowes, Wallmart, etc) Good luck!

try LA,S TOTALLY AWESOME its chemical free......

How do I unlock wolf stove top?

First, determine if the burner element works by swapping it with a similar sized element on the stove. The eyes pull up and out away from where they go under the deck. If the burner works, the problem is likely with the receptacle, which is located below the deck. Trip your stove breaker, which is located at the panel by your meter. Make sure that the power is off completely. Raise the stovetop (deck) by lifting the front edge of the deck sharply. Some tops have a rod to hold them up; some do not. The receptacle has a screw that holds it to the top, and sometimes a clip. You can check the voltage at the receptacle. If the receptacle has any evidence of chipping, or having been burnt or damaged, it should be replaced. Replacement receptacles can be obtained at Lowes, H/Depot, similar. You'll have to cut the wires on the old one, install the shrink tubing, install the new receptacle, make up the connections, tape them up and apply the shrink tubing supplied. Sounds like a lot, but there relly isn't much to it. It takes longer to tell it than to do it! (Once you've done it a few times!)
Best regards, --W/D--

Do not attempt if your stovetop is hot, you will get burned!!

This is an easy fix, the problem is your burners aren't lined up properly. Remove the iron grates (what your pots rest on) and the burner cap (the round black top on the burner) and finally the burner base (the round golden colored piece resting on the stainless stovetop). If you flip the base over you will see that it is keyed, meaning there is a grove that fits the indentation on the stove top. When you replace the base make sure to line the grove up with the indentation. If it's not flush with the stove top, slowly twist the round burner base until it falls into place. That's it!

DeBruce Polish should remove those types of problems and also render the surface more "Cleanable". This stuff really works on glass anomalies.

Check out debrucepolish.com.

DEBRUCE METHOD on You Tube

I'm happy to say burnt milk can be removed with a combination of cerama bryte and let sit for one hour and then lots o elbow grease hard rubbling with also applying Mr. Clean Magic Eraser. The Mr. Clean Magic Eraser works very well but you have to still rub alot to get it safely scratch-free removed.

I want to say that since I posted my original problem with black spots appearing on the Schott Ceran top, I took pictures of the top and attached them to a complaint sent to Maytag. Approximately 3 days later, a Maytag representative phoned and offered a brand new top-basically stating that there is a fault with the tops. They would not pay for the labor to replace the top. My husband downloaded the instructions from Maytag website and installed it himself. These spots actually appear from within the surface and are not the result of a boil over, etc. The spots on my burner grew to the width of the burner. If you search the internet, you will see many others with the same problem with the Schott Ceran tops. I will never buy another!