20 Most Recent
HP LaserJet 1010 Printer - Page 6 Questions & Answers
Printing error
my printer became paused and i am unable to print any thing
Light printing problem.
First, replace the toner cartridge for a new one (Q2612A)
If not work, clean the laser/scanner lens.
I have a grey/black line
Run a half test.
Put paper in the manual feed tray.
Print something, anything
When the paper is 1/2 way into the printer, open the cover.
Pull out the toner cartridge. Look down at the paper.
Does it have a black line on the right side?
If yes, replace the cartridge. If no, replace the fuser.
Downloaded the hp1010 laserjet driver
In most cases the printer driver software can have errors while being in use or is shut down. So to reset remove your printer from the PC and uninstall the printer software or any associated printer driver software from the PC. Now reinstall the printer software and then connect the Printer to be detected as a new hardware as it will be installed. Now check the printer properties. If not there are errors in the mother board.
Which cables are required for HP laserjet 1010
Hi,
2 Cables are required. First to connect the printer to the computer (USB Cable) and second to connect the printer to the power source (Power Cable). These can be bought from
any Computer Accessories store. Below is the picture of the USB cable. The
normal USB plug (on the left) goes to the USB Post of the PC and the
square one at the right should be connected to the printer.
Hope it helps! Good Luck! Thanks for using Fixya!
CreativeTECH
My hp laserjet 1010 printer
sometime, it is very silly but true, we forget to check the connectivity of the printer to computer. Plz check unplugin and plug in back the cable attched to printer and computer. Then restarting both computer and printer. If that does not solve, then uninstall and reinstall the printer software.
Hi
My HP printer is laserjet
With just a few pages in the tray, send a job to the printer and at the same time look into the printer where the paper is. You will see if the paper pickup roller turns or not.
If the paper tray rises to where the pickup roller is and the pickup roller rotates then the problem is that you have a worn or dirty roller. The roller can be cleaned with a number of liquids but try warn water on a cloth first. Also if yiou take the toner cartridge out, you will have clear access to remove the roller or clean it. I have also removed the roller and then rotated the rubber tyre a little so that the worn part is not in use.
Not finding what you are looking for?