Top 20 HP LaserJet 1010 Printer Questions & Answers

Try a hard reset of printer and/or reinstall the software, Check cartridges for ink and operation.

Try a different cartridge, blank horizontal would point towards a possible drum issue. Does the defect repeat down the page?

put hp Genuine Cartridge

Means that your cartridge is still functional but of older date. HP warns because the age of cartridge may negatively impact print quality. It is just annoyance, you should print without any problems. Regards, Mike

check pressure spring lubricate fuser under film ensure well assembling

Remove Old Printer Drivers Take you time and if you get stuck ask. Good Luck.

Check your toner savings settings and adjust it accordingly.You may also experiment with the right kind of paper. Regards, Mike.

There are 2 cause for this problem
1st possible cause is the fuser ( either resistance doesn't go to correct temperature, or temperature sensor is damaged and doesn't read the correct temp )
2nd formatter board needs to be replaced or the main chip needs to be replaced

If you have tried some of the above options and it didn't correct the issue then your print job is hung in your queue. Open Printers and Faxes and double click the printer in question. You will see a queue that most likely has a job there trying to print. Right click on the line item and select cancel. Most times it will it delete quickly so I wait a minute or so and if it still doesn't clear just reboot the PC while the job says deleting. Once it's back up and running go back to Printers and Faxes and double click the printer again a day make sure the queue is empty. Lots of times when a job is hung there many other jobs piled behind so they all need to be cleared out before you try printing again. Good luck

this is a fatal error. If you hold the go button you should get a different light patter which I can decode and tell you what the problem is if you post back.

the two lights are stable mean its on and the one blanking mean its working

Hi - Would you be able to answer a couple questions to better diagnose your problem? Using genuine HP cartridges? Windows 7 machine? Setup for local one computer use? Thanks.

https://www.youtube.com/watch?v=Nc6J158_V9M

clutch unit problem .You should service

Not supported, purchase a new printer. This is a home printer, never intended for server environments. This is a host based printer and has no internal PCL board to convert print stream from current windows.