Blower motor does not work replaced blower motor but still willnot work

What voltage checks have you done? It doesn't leave much other than the wiring and I assume you have checked there's a power feed from the fuse which you will have checked? A corroded connector seems likely. Check continuity and voltages through the wiring, and look very carefully at the connectors near the blower for heat damage or corrosion as that's the most likely point of failure

it might be the switch but chances are the motor is shorting inside when u are trying to put window up . so you will probably have to replace the motor/regulator assy

Its faulty blower motor resistor. The low and medium speed on blower motor is controlled by resistor and its actual speed is high. So because resistor is not working, blower motors actual speed which is high is working.

It can be faulty blower motor or faulty blower motor resistor. Get the blower motor inspected. If it's faulty it has to be replaced.

=======

For blower motor testing and replacing, check the link below: ----

Blower motor Testing/replacing for all vehicles?

http://repairhelpcenter.blogspot.in/2012/02/blower-motor-replacing-for-all-vehicles.html

------------

These will help.

Thanks.

Its faulty blower motor resistor. The low and medium speed on blower motor is controlled by resistor and its actual speed is high. So because resistor is not working, blower motors actual speed which is high is working.

It can be faulty blower motor or faulty blower motor resistor. Get the blower motor inspected. If it's faulty it has to be replaced.

=======

For blower motor testing and replacing, check the link below: ----

Blower motor Testing/replacing for all vehicles?

http://repairhelpcenter.blogspot.in/2012/02/blower-motor-replacing-for-all-vehicles.html

------------

These will help.

Thanks.

Its located under dash,or near glove box.

The dash panel lower side has to be out.

HEATER BLOWER MOTOR

Its faulty blower motor resistor. The low and medium speed on blower motor is controlled by resistor and its actual speed is high. So because resistor is not working, blower motors actual speed which is high is working.

It can be faulty blower motor or faulty blower motor resistor. Get the blower motor inspected. If it's faulty it has to be replaced.

=======

For blower motor testing and replacing, check the link below: ----

Blower motor Testing/replacing for all vehicles?

http://repairhelpcenter.blogspot.in/2012/02/blower-motor-replacing-for-all-vehicles.html

------------

These will help.

Thanks.

HEATER BLOWER MOTOR

Its faulty blower motor resistor. The low and medium speed on blower motor is controlled by resistor and its actual speed is high. So because resistor is not working, blower motors actual speed which is high is working.

It can be faulty blower motor or faulty blower motor resistor. Get the blower motor inspected. If it's faulty it has to be replaced.

=======

For blower motor testing and replacing, check the link below: ----

Blower motor Testing/replacing for all vehicles?

http://repairhelpcenter.blogspot.in/2012/02/blower-motor-replacing-for-all-vehicles.html

------------

These will help.

Thanks.

It can be faulty blower motor or faulty blower motor resistor.Get the blower motor inspected.If its faulty it has to be replaced.

=======
For blower motor testing and replacing,check the link below:----
Blower motor Testing/replacing for all vehicles? http://repairhelpcenter.blogspot.in/2012/02/blower-motor-replacing-for-all-vehicles.html

------------
These will help.
Thanks.

Sounds like the terminals are worn out, or have a short. If you can get to the blower motor, try taking off the terminal set, applying some silicon dielectric grease, and putting it back on, making sure the connection is locked down tight. If it cannot be locked tight, try getting a new connector. It could also be a short in the wires going to the fan, or a short inside the fan.

If you have checked the fuses, it could be the blower motor is dead, or the switch is no good. Put a test light on the wire on the motor, and turn your switch on, if there is power, then it's probably your blower motor. If there is no power, it's probably the switch, or a wire.

Check the connections at the blower resistor.