...2004 GMC Canyon 2.8L 4 cyl w/5speed. the 3 lowest settings on AC/Heater blower motor does not work. It only works on the highest setting. The Canyon has an inherint problem with the Fan Power cable ...
...2004 GMC Canyon. No it's not a resister issue because I already went to the GM dealer to get the replacement resister, Installed it and it still only works on 4. Try bending the prongs on the ...
...2004 canyon when I turn the fan on (settings 1, 2, or 3) it will run for a while then kick off and as soon as I put it on setting 4 it comes right back on but will not work on any of the lower ...
Question about 2004 Canyon
...blower motor works on high. intermittent on other speeds. The blower motor works on speed 4 when the dial is set on 4. However, on speeds 1,2,3 the blower works intermitently. The motor woks on speed ...
blower motor does not work replaced blower motor but still willnot work I dont think that the blower has a fuse just a relay. try replacing it and see if that helps.
the temp control fan only works on the highest speed Blower motor resistor. also the wires going into resistor backs out of plug..mine did...
...but does work on 4/hi this is only the fan/blower. what causes this& how do I fix it? replace blower motor resistor located near blowermotor I have the same problem... how much was it to
heater fan only works on high This is caused by a defective blower motor speed control resistor, the resisitor is located next to the blower motor.
...blower only works on high is it the switch or resister That is usually caused by the resistor module for fan motor speed control. Replacement is quick and not very costly have the same problem wiggle ...
2004 canyon no voltage at heater resistor heater not working at all no voltage at heater resistor with key on or off The resistor provides the ground circuit for the blower motor. So you would need to
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions