Do you work here? Claim your company
Hi,
Take the razor apart .First remove the foils, then the blades. Pull them up after unbolting 6 screws. There are two screws to remove where the head rotates. Then after removing the head, there are two more screws under the head. You will find two more screws on the bottom under the plastic caps beside the charging terminal. Now slide the razors hardware efficiently and carefully out of the case by pulling up from the head mounting arms while holding the case as you normally do while shaving.
After the circuit board is exposed, gently clean it with small amount of alcohol and q-tips, make sure nothing gets stuck on the components of the board like cotton or cotton threads .You can also examine if the motor is not burnt out and the batteries are charged up by placing a flathead screwdriver between the positive terminal of the battery and the motor. It should come on if the motor and batteries are good. Now reverse the procedure carefully to reassemble the razor. After tht press the reset button of the razor at the bottom-front, and check if it comes on using the on/off button.
Please get back to us if you have further query else please accept the suggestion.Thank you for contacting fixya.com
I figured out the problem for my Clean & Renew unit. Mine is 2 years old. About 3 months ago, I cleaned the buildup of whisker material from the TOP of the drain port [Left Side as you look at the unit] If you take out the cleaning solution cartridge and turn the unit upside down, you see the pump and the return ports. The return port is the smaller of the two. I found that there was a mass of dried whiskers in a few clumps clogging the return port. These clumps must have come loose and got caught within the drain port. I had noticed when I had the leaking problem I could hear bubbling just after the pump ran and the shaver turned off. I removed the clumps of whiskers and no more bubbling sounds and NO MORE LEAKS. My guess is that the fluid was draining back into the intake area and leaking on top of the cartridge. Hope this helps.
Usually answered in minutes!
271 Questions
132 Questions
101 Questions
74 Questions
72 Questions
