Gentlemen,ladies thank you for you alls helpful insight on the husqvarna455 could not get the chain cover off .got the cover off but cant seem to get cover back on due to fact that the metal band will not go over the brake clutch assembly need help.

That error is related to the scanner not being in the right position (home) when it starts. This could be because the scanner is jammed, is not reaching the home position or the sensor for the home position is bad.

its a breather pipe im not positive but usually u twist and turn pulling on it to remove, its a interference fit the timing chaine cover is just stuck there is a gasket some times people put sealant on it u will need to use a very thin screwdriver and pries it open once u break seal it will b easy ,..u must re seal after u have finished fitting it or there will b oil every were leaking

Ladies and gentlemen I have a 2002 ram 1500. 5.9 magnum V8. If you've already replaced your sensors as in cam aka pickup coil located in distributor and crank stop there. Reason why is 1 question. Did you replace your transmission. If yes let's talk about the flex plate. If it has the slightest bend then that's the problem. Some aftermarket crank sensors can be too long. You tighten it down and couldn't tell. I've dumped thousands into mine. Low compression cracked heads. I bought new heads timing gears and chain distributor spark plugs wires lifters and rods. So all that for a 20$ flexplate. As soon as I replaced it started the truck instant fix. No rough idle smooth as can be.

u can go to this web site for help in this matter at appliancerepairplanet.vstore.ca

It really depends on which model 455 rancher you have. The "455e" models have a lever on the chain cover that you lift and turn counterclockwise in order to remove. The regular 455 models have two nuts that you remove in order to take the chain cover off. There is also a chain tensioner on both. On the 455e model you turn the wheel down to increase tension and on the 455 you turn the screw below the foremost nut to tension. Remember that you want to just snug the chain to the bar. You should be able to rotate the chain around the bar by hand.

Fuse is behind the control panel. Has cavity sensors and a magnatron thermal disc also. Start with the fuse and then pull it down if not the problem. Eric

I'm a lady,but I'm willing to help.lol
Try this site and hopefully you will find exactly what you are looking for.
www.onlinefreeebooks.net/automotive-machinery.../suzuki/

Canon USA has manuals for Zoombrowser available for download from their site, but they're all in English. If you have ZB version 6 you can download the manual here. If you have ZB version 5, you can download the manual here.