20 Most Recent
Husqvarna 28cc Gas Line Trimmer - Page 7 Questions & Answers
Shaft connection bad,head slips under acceleration
Slacken off the 'tube shaft' retaining clamps at eithr end of the drive tube. Push tube back in towards the engine and resit the shaft and tighten clamp screws, repeat the same with the gear head on the other end.
Pull start spins
Remove the starter recoil, you may find you have damage to the starter pawl.
Model 128 cd string trimmer carb problems
You may have damaged the carb by blowing out with air. Carbs contain tiny one way valves which are very delicate and can be damaged by cleaning with airlines. Do you have a good continuous spark? Do you have good compression.? Is fuel getting into the cylinder.?
Trimmers hesitate and quit running
Check fuel is getting into the cylinder, check you have good compression, check you have a good strong continuous spark. Once you have checked all these, please provide more information. Thank you
How do you keep the shaft from turning when working on it
If you're refering to working on the cutting head without the shaft turning then you should be able to lock the cutting head to remove it. There is a small hole in the top of the gear head that you need to put a small rod in to jam the head from turning.. this inturn will also stop the drive shaft from turning.
Husqrvana trimmer stalls
It could be a number of things. Possible over heating issue. But most likely to be a fueling problem, some machines have the tendancy of creating a vaccum in the fuel tank which prevents fuel beind drawn up by the carb.
Not finding what you are looking for?