Top 20 2002 Chrysler PT Cruiser - Page 4 Questions & Answers

when using key it like house alarm you have a few seconds to enter passcode to reset same with car you have a few seconds to enter and put key in ignition and turn on this resets alarm

This is going to be a transmission problem.

Shift solenoid problem , your best bet would be to take your vehicle to a qualified repair shop an have it diagnosed . This is more then likely an electronic problem . Have diagnostic scan tool hooked up , check for DTC'S - diagnostic trouble codes .

I think this is the oil pressure light not the low oil level light, so have the oil pressure tested by a shop and make sure it is within specifications or serious damage to the engine will result. If the pressure is ok then replace the oil pressure sending unit it is faulty.

Jim what kind of car or truck please

Look to the right of the radio display, hopefully you will see an "H" and a "M" either side-by-side or the "H" above the "M" and slightly recessed buttons below the letters. Use an ink pen or something of equal size and GENTLY push the recessed button, you should see the "hour" (H) and "minutes (M) change. The radio has to be "ON" All Day 24 Hour Locksmith Williamsville NY 716 250 0360 Locksmith...

You can't that's why you have one. Otherwise there would be no point in it. If you have lost your key, you will have to get a replacement one from the dealer or reputable locksmith.

Catalic converter damaged

Are you sure you installed the timing belt correctly? I will bet it is off one tooth.

The blinkers run though the Hazard switch. Have you done work recently on the radio or anything in the dash where it could have come unplugged? I would check the switch and make sure it's all connected there first. I have seen several people with this issue and most just recently installed a radio (or had one stolen) and the hazardbutton never got plugged back in... Locksmith Kenmore Ny 24 Hour Locksmith 716 848 0099 in Kenmore Ny

local paper advertisement--- cars and trucks section local radio that has a sell swap and by session notices on local notice boards --shops etc some wreckers will pay around that for late model cars to wreck find a chrysler car club and advertise on their monthly magazine

if the helicoil was installed correctly there should be no probs when done correct the coil replaces the origional thread and stays put should not come out when you remove the plug.

There is a fusible link for the alternator that is probable failure

What do you mean by seams to fire but won't Start ? When you turn the key to start what happens ? Does the starter spin the engine ? If so this would be a engine cranks , now if it does spin the engine an the engine doesn't start an run this is call an cranks no start condition .Now on the other hand if the starter doesn't spin the engine when you turn the key to start ,then this is referred to as a no crank - no start . There are very different diagnostic steps for each of these conditions . Your best bet is to have your vehicle diagnosed by a qualified technician .

fuel fillter or pump

check your fuses look for ignition fuse make sure it's not blowed

P1489 OBD Trouble Code

A clunk sound is usually a CV joint.

Have you had work done in this area recently? If not then its possible it doesn't connect to anything on your model.

There are two types of PT Cruisers, those that the multi-function switch (the one on your steering wheel that controls turn signals/foglights) HAS failed and those that it WILL fail. Yours probably has failed and your fog lights come on whenever they feel like it, even if the car is parked with no key in the ignition, thus your need for a new battery. You can find the replacement part on Amazon (Amazon com Shee Mar SM147 Turn Signal Fog Lamp Wiper Dimmer Multifunction... ) or have your mechanic replace it.