Chrysler Cars & Trucks - Recent Questions, Troubleshooting & Support



Hi buddy,
Would suggest ya to try some online manuals.. if u know a good website then go ahead or otherwise try reliable-store.com
It's great for automobile repair and the people are also very helpful..
All the best:)

Chrysler Cars &... | Answered 16 hours ago


DEPENDS ON WHICH ONE YOU ARE WORKING ON AS TO WHAT IS IN THE WAY OF IT

Chrysler Cars &... | Answered 3 days ago


There are lots of issues with the multifunction switch for Chrysler

2012 Chrysler... | Answered 3 days ago


Chrysler Pacifica P0131: O2 Sensor Low Voltage (Bank 1 -Sensor 1) P0131 is a common OBDII code that occurs in many vehicles, including the Chrysler Pacifica. It is letting you know that there is an issue with the wiring or harness going to the sensor, or the sensor itself is bad.Feb 1, 2019

Chrysler Pacifica P0131: O2 Sensor Low Voltage (Bank 1 ...


https://www.700r4transmissionhq.com > p0131-chrysler-pacifica

Chrysler Cars &... | Answered on Dec 01, 2019


The EGR valve is located at the rear of the engine, on the right side. The wiper arms, cowling and wiper transmission assembly all need to be removed to access the EGR.

Chrysler Cars &... | Answered on Dec 01, 2019


low voltage o2 sensor bank 1 sensor 1 the computer registered a fault that the o2 sensor had lasted over 2 minutes problem faulty o2 sensor --short in sensor/wiring--short in wiring circuit sensor 1 is the sensor before the cat converter

2004 Chrysler... | Answered on Dec 01, 2019


Sounds like loose wheel bearings and front struts if it has them.

1999 Chrysler... | Answered on Nov 28, 2019


power steering fluid or dextron 3 trans fluid

2001 Chrysler PT... | Answered on Nov 28, 2019


"NO BUS" means that your insturment cluster is not communicating with the onboard computer. Your cars have a "data bus" the same as a personal computer. It is basically just part of the Chrysler computers wiring system.

Try checking plug in connectors in your wiring system. This could possibly be somewhere besides behind the instrument cluster, such as at the computer. Another thing to check is the ground system. I don't know about your particular vehicle, but I have found a few vehicles with a loose ground wire, which was driving the instruments crazy. In those cases, there was a ground wire with a metal grommet attached to the metal body or dash structure somewhere under the dash. I have found on some vehicles it is attached on the left side under the edge of the dash right above the emergency brake pedal.

I hope this helps.

2006 Chrysler PT... | Answered on Nov 25, 2019

Not finding what you are looking for?
Chrysler Logo

49,842 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Chrysler Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...