20 Most Recent 2000 Ford Excursion Questions & Answers

0helpful
2answers

My ford v10 engines hesitates under load. It

1 Ignition system not operating properly
2 Dirtyor clogged fuel injector(s).
3 Low fuel pressure. Check for proper operation of the fuel pump and for restrictions in the fuel filter and lines.
4 Fuel injectionor engine control systems malfunction.
5 Vacuum leak at the intake manifold or vacuum hoses.
6 Restricted air filter.
7 Fuel pump or pressure regulator defective.
1/17/2022 1:34:35 PM • 2000 Ford... • Answered on Jan 17, 2022
0helpful
1answer

What vehicles will interchange parts with a 2000 ford excursion

A salvage dealer would know
7/20/2021 4:42:52 PM • 2000 Ford... • Answered on Jul 20, 2021
0helpful
1answer

Need fuse relay diagram for ford excursion 2000 v10 4wd

Him trying to put the batterie cables on the batterie to charge it because it's dead but at same time the horn goes on then I take the cable off the the batterie it shuts off nd I wanna know where is the fuse at to remove it but my fuse box dnt have a cover on it so I cant tell which fuse it is
1/5/2020 8:33:22 PM • 2000 Ford... • Answered on Jan 05, 2020
0helpful
1answer

2000 ford excursion 6.8l v10 will start on first try when cold, but it takes 2-3 times of cranking when engine is warm.

run fault codes indicate ambient temp sensor , maf,vaf or engine coolant temp sensor problems
5/5/2018 11:20:57 PM • 2000 Ford... • Answered on May 05, 2018
0helpful
1answer

2000 ford excursion. OD light blinks, shifts hard,

If you've changed the sensor and still getting the code, then the problem is either a wiring harness issue OR, you really do have an internal transmission problem.
1/1/2018 3:59:33 AM • 2000 Ford... • Answered on Jan 01, 2018
0helpful
1answer

Trouble code indicates all four glow plug on the left side bad

The garage should be able to test the glow plugs without removing them. All the need to do is use an ammeter or amp clamp and measure the current drawn by the glow plugs. the glow plugs should draw 16 - 20 amps each. much less than that and they want replacing.
11/9/2017 2:30:02 PM • 2000 Ford... • Answered on Nov 09, 2017
0helpful
1answer

I have a 2000 Ford Excursion - 7.3 Diesel. A/C not cooling in low RPM but system has freon

Hook up a AC test gage to the low side pressure port under the hood, it should read 28-32 PSI, if not your system is low on charge.
7/5/2017 10:06:31 PM • 2000 Ford... • Answered on Jul 05, 2017
0helpful
1answer

My2000 ford excursion wont completely disengage out of 4 wheel drive

Sometimes you have to back up about a foot to disengage the hubs.
2/10/2017 11:42:00 PM • 2000 Ford... • Answered on Feb 10, 2017
0helpful
1answer

How does the back bumper of the Ford Excursion attach?

The process is like the Super Duty trucks, so watch the video at the link. How to Fix F250 Super Duty Rear Bumper
9/7/2016 5:46:50 PM • 2000 Ford... • Answered on Sep 07, 2016
0helpful
1answer

Why can't I start?

If the speedometer works and odometer doesn't it is mostly chip failure. Ford put the security in the cluster also. For a few years. Replace the cluster. You also have to have the system reprogrammed.
4/12/2016 12:00:10 AM • 2000 Ford... • Answered on Apr 12, 2016
0helpful
1answer

How to remove fuel filter on a 2001 f250 v10 gas truck

I just purchased a 1999 F-250 Super Duty with the V-10 engine. It was running rough, so I took a chance on some after-market coils. I bought a set of 10 for just over $75.00 shipped (for all 10 total!!!). They came with new boots, too. They smoothed out the engine just fine and, of course, increased my fuel mileage, too. There ARE reasonably priced parts out there if you shop around.
3/22/2016 5:31:06 AM • 2000 Ford... • Answered on Mar 22, 2016
0helpful
1answer

What parts do i need for a tune up

if it is an EFI engine then the parts that you will need for a tune up will be indicated in the fault codes The ECM of the vehicle continually tunes the engine while running ( around 100 times a minute) and as long as all the sensors are within parameters ,the engine will remain in tune any sensors that are failing will leave a fault code and just because the engine light is not on doesn't mean that there are no fault codes recorded basically "good mechanics do not fix what isn't broken"
8/31/2015 4:29:10 AM • 2000 Ford... • Answered on Aug 31, 2015
0helpful
1answer

Is there in line fuse from alternator to battery

Yes,coming from the positive side of battery.
8/26/2015 1:21:40 AM • 2000 Ford... • Answered on Aug 26, 2015
0helpful
1answer

Battery light stays on when running?

Check and make sure the alternator is charging, if so...check the single wire connector at the alternator.
8/26/2015 12:16:23 AM • 2000 Ford... • Answered on Aug 26, 2015
Not finding what you are looking for?

532 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Excursion Ford

  • Excursion Ford

Most Popular Question

ford v10 engines hesitates under load

  • Cars & Trucks
Loading...