Top 20
2000 Ford Excursion Questions & Answers
Trouble code indicates all four glow plug on the left side bad
The garage should be able to test the glow plugs without removing them. All the need to do is use an ammeter or amp clamp and measure the current drawn by the glow plugs. the glow plugs should draw 16 - 20 amps each. much less than that and they want replacing.
11/9/2017 11:21:03 AM •
2000 Ford...
•
69 views • 0 helpful votes
Why can't I start?
If the speedometer works and odometer doesn't it is mostly chip failure. Ford put the security in the cluster also. For a few years. Replace the cluster. You also have to have the system reprogrammed.
4/11/2016 10:59:06 PM •
2000 Ford...
•
82 views • 0 helpful votes
New alternator not charging 2000 Ford Excursion V10
Check for blown fusible link and possible bad relay. On relay, with everything off and hot battery hook u battery and give it ten minuets or so, then feel the top of eac relay. if you find a warm or hot one Bingo!
7/13/2015 6:49:38 PM •
2000 Ford...
•
1,709 views • 1 helpful votes
What parts do i need for a tune up
if it is an EFI engine then the parts that you will need for a tune up will be indicated in the fault codes
The ECM of the vehicle continually tunes the engine while running ( around 100 times a minute) and as long as all the sensors are within parameters ,the engine will remain in tune
any sensors that are failing will leave a fault code and just because the engine light is not on doesn't mean that there are no fault codes recorded
basically "good mechanics do not fix what isn't broken"
8/31/2015 3:36:41 AM •
2000 Ford...
•
234 views • 0 helpful votes
Why won't it turn over?
There is a starter solenoid under the hood on in side the right side fender . close to the firewall on the right side. the small wire is the trigger wire, see if you get power when you turn the key to start on that wire.
7/30/2015 8:40:00 PM •
2000 Ford...
•
147 views • 0 helpful votes
Not finding what you are looking for?