Frigidaire Washing Machines - Page 8 - Popular Questions, Answers, Tips & Manuals
My frigidaire gallery washer jumps around on the
Two thoughts come to mind;one is that the load is not distributed evenly in the tub, try distributing the load by weight more evenly; two perhaps the feet of the machine are not set for even contact with the floor.The machine should not rock from corner to corner
2/14/2018 2:42:03 PM •
Frigidaire...
•
88 views • 0 helpful votes
Spin cycle not working
you will need to unplug the machine and take off the back panel and look for a small 5mm pipe leading upwards, take it off and blow gently into it you should hear a click and another one when you let the air out again if so then the small pipe where you took it from is blocked preventing the switch to work properly , unblock the pipe with a pipe cleaner or metal rod its normally full of soap goo return the pipe and close the back up and run the machine again eric
1/5/2018 12:51:02 AM •
Frigidaire...
•
232 views • 0 helpful votes
My Frigidaire Affinity ATF6000FS1 front
It's the timer control, not the motor or filter. Try a different setting. You should also be able to find more information on the manufacturers website, along with a manual and possibly a diagram. Also You Tube is a good place to find out more on how to repair it.
12/3/2017 7:54:04 PM •
Frigidaire...
•
523 views • 0 helpful votes
Door lock does not work
try checking it out here
appliancepartspro.com or repairclinic.com
have your model #
sb inside the freezer compartment or frig.
1/21/2018 4:54:03 PM •
Frigidaire...
•
122 views • 0 helpful votes
Will not complete the final
there seems to be a problem in the water pump as its not draining properly check that there's not a button or other debris in the system first eric
12/29/2017 2:54:03 PM •
Frigidaire...
•
220 views • 0 helpful votes
WHAT IS THE CAPACITY OF THE FRIGIDAIRE HORIZON 2000?
Measure the height of the drum in inches. For example, a drum might measure 36 inches high.
Measure the diameter of the drum. This is the distance across a circular end. For example, the diameter might measure 18 inches.
Divide the diameter in half. This gives you the radius. For example, half of 18 inches is 9 inches.
Square the radius. Multiply the radius figure by itself to square it. For example, 9 inches squared is 81 inches.
Multiply the radius squared times pi times the height of the drum. Pi is approximately 3.14159265. The final result is the volume of the drum in cubic units, the same units you used to make the measurements. For example, calculate the radius squared (81 inches) times pi, then times the height (36 inches). The result is approximately 9,160 cubic inches.
12/2/2017 3:51:26 PM •
Frigidaire...
•
458 views • 0 helpful votes
I have a Frigidaire Front Loader Washer Model #
You need to lean it back and remove the lower panel, you will have complete access to the water pump, disconnect hose clamps,remove and clean the rubber boot,disconnect electrical connector and 2 screws holding pump, Replace with new pump, before beginning take pictures to ensure proper installation
11/19/2017 6:30:04 AM •
Frigidaire...
•
542 views • 0 helpful votes
Frigidaire washer spins but won't agitate
when you try to spin the Agitator dose it spin freely both ways if so the DOG EARs are stripped and need replacing Take cap off top off agitator to access the bolt holding the n in place and the Agitator off
10/22/2017 4:36:03 PM •
Frigidaire...
•
1,091 views • 0 helpful votes
Not finding what you are looking for?