Amana Heating & Cooling - Page 8 - Popular Questions, Answers, Tips & Manuals
Heater, ac and fan speeds all working fine. Compressor not kicking in...just auxiliary heat working.
Outside temp too low, so outside thermostat and it's settings will not allow the heat pump to work. But insist on the ausilary heat to work instead. Heat pumps usually do not produce enough heat when below 40F outside temp. If you have Gas heat, it may be more economical than the heat pump below 40F. If electric auxilarry heat, it may compete at 32F. Talk to your dealer, installer, or manufacture.
3/4/2015 1:32:37 AM •
Amana...
•
220 views • 1 helpful votes
Hear pump keeps running constantly, why won't it shut off?
if some units detect ice they will leave the fan running in an attempt to defrost the coils. If it's the outside coils and it's warm enough inside, try running the air conditioning for a few minutes, that will put hot coolant through the coils and could melt the ice for you.
3/16/2015 5:10:41 PM •
Amana...
•
119 views • 0 helpful votes
Fan runs all the time and no heat
br means brown out protection engaged. Power was lost or voltage is to low, check for incoming power at correct voltage
3/10/2015 10:11:01 AM •
Amana...
•
98 views • 0 helpful votes
Fan won't stop even when thermostat removed.
If you have a digital thermostat. You should first check the programmed settings. Most probable cause is the main relay. First you need to disconnect the power from the system. This can be done by flipping the circuit breaker. Make absolutely sure that the power is off before removing the service panel. The main relay is probably located at the air handler. (Big metal box near where you change your filter.) Remove the service panel and locate the relay. It will look like a plactic box with 4 or more wires connected to it through the controller. Once located, tap on it gently with the handle of a screw driver. Replace the panel and restore power to the system. Make sure everything is turned off before restoring power. If that works then you will want to contact a reputable HVAC shop to replace the relay. Btw, I’m available to help over the phone in case u need at
https://www.6ya.com/expert/john_28069c9efb56199d
3/4/2015 7:52:37 PM •
Amana...
•
74 views • 0 helpful votes
Induction fan comes on ignitor wont ignite
If the igniter turns orange and the gas fires for only a second or two then your heat sensor needs to be cleaned with sand cloth, if it does not turn orange then your igniter needs to be replaced.
1/17/2015 4:24:25 AM •
Amana Gas...
•
163 views • 0 helpful votes
Not finding what you are looking for?