20 Most Recent
Konica Minolta Bizhub C451/c550/c650 Toner Magenta A070330 - Page 6 Questions & Answers
Error Code C-6701
Any one of theses:
CCD board (CCDB)
Exposure lamp (L1) My Number #1 does the Bright Light under the big glass come on?
L1 inverter (L1 INVVB)
Scanner motor (M2)
Overall control board (OACB)
Cara perbaiki kode 3801 bizhub 420 minolta
This is a under temp code from Temp sensor 1 (TEMS/1). You should check your thermistor, clean it. Then you have to reset the code.
To reset: Go to DipSW 3-1 and set to 0.
You may have a bad sensor or heat lamp.
Hope this helps.
Bizhub 164 error code c4101
Polygon Motot Error
Turn OFF and ON the power switch. 2 Check the connector between PH unit- PRCB CN1, CN2 for proper connection and correct as necessary. 3 Change PH unit. 4 Change PRCB.
I have a bizhub 4750 and i need to know the service mode password to enter tech rep mode. many thanks Brad
1. Turn on your Bizhub 4750 laserjet printer and wait until it sets to normal mode.
2. Go to the Control Panel Settings on the printer.
3. Scroll down and select the Utility or Counter menu.
4. Navigate to the bottom of the screen and open the Details tab.
5.Look for a message stating [STOP][0][0][STOP][0][1]
6. Go to the Counter menu again and scroll down to the bottom.
7. Clear the cache memory under the Developer & Drums menu.
8. Connect your printer and computer over a network connection.
9. Run the F8 program from the Functions menu.
10. The service mode password will display on the screen after a while.
Bizhub 458e jam code 30-03 how do I resolve this...
Description
The leading edge of paper is not turned ON (unblocked) the paper exit sensor (PS3) since the paper feeding is started.
Causes
• Transport motor (M1) • Fusing motor (M3) • Registration clutch (CL4) • Registration sensor (PS1) • Paper exit sensor (PS3) • Front side board (FRB) • MFP board (MFPB)
Where is reg roller on bizbub 3510
The registration roller is not causing the print sync issues. It is the sync clutch on the right side of the transfer assembly that is located in the right door that folds down. It is easily replaced and can be found in numerous places online.
BIZHUB C554 ERROR CODE C - 3B07
1 Check the connection of the fusing unit. 2 Check the fusing unit, IHC, IHPU and PRCB for proper connection and correct or change as necessary. 3 Replace IHC 4 Replace IHPU 5 Replace PRCB
Turn machine on holding down the utility key.Trouble reset and Turn off machine.Good luck.
Error c2554 in bizhub c353
1 Reinstall imaging unit. 2 Reinstall toner cartridge. 3 M3, M4 operation check (At this time, IU must be non-installation.). 4 Change imaging unit. 5 Change PRCB
If you do not use the original toner. May cause problems.
Make sure you only copy red in order for the red to be normal.
When the machine displays the code, you open and close the front bezel and retry until the code is not displayed.
Not finding what you are looking for?