20 Most Recent Konica Minolta bizhub 161f All-In-One Laser Printer - Page 3 Questions & Answers

yes there is and you can call the support line and ask them they will tell you

Try to replace the 'paper is present' sensor with the 'cover open' one to see if now it is detecting the paper. Also, check the actuator that enter in that sensor.

Connect the machine through USB to your computer, install it as printer (the scanning driver will be installed in the same time). Go to your favorite graphic application, go to File menu and you should find 'Scan' or 'Acquire'.

Try a different version of your driver.

Yes you can send fax from ppc to konica. As long your konica is network and the function feature is turn on. I setup this features to my customers I been doing this 6 years and to the newer konica minolta machine.

go to Start... click Run .... type services.msc and find print spooler right click stop and click start again

hi
you can download the software from the following link

http://onyxftp.mykonicaminolta.com/download/SearchResults.aspx?productid=832&filetypeid=0

Usually a fuser unit isn't a replaceable item by the end user. It requires a service technician to repair because they are wired to a circuit board and there are glass components in them that have to be handled carefully.

help me my konico minolta bizhub 184/164 error (C2558) my mail id - [email protected]

Must installed hard disk

KONICA MINOLTA BIZHUB 211 FUSER UNIT 230V / 4034r70100 (surplustoner.com) Here is the image of the fuser

Open the mid section of the copier and pull out main section. Then re-install. The code mean the the fuser (The large device on the left hand side that melts or fuses the toner to the paper is not connecting properly to the electrical connections in the back where it plugs into. Could be that the connector is broken because some slammed the mid section to hard. Or that you need to give the section a better/some what harder push when you close it. Might want to remove the FUSER unit and put a flashlight to the back make sure the connector is ok and check the connector on the fuser itself!

Check all fans located inside the machine

Replace the drum and developer. Clear the associated counters first in service mode. Then replace the developer and drum then run the F8 procedure in service mode.

A/C signal out your wall outlet or the you are using a European model machine in the US or vise versa. Also check the electrical cord

Requires you to access service mode first, then Stop, 0, Clear.

What is Polycope? What is prechaufage?