20 Most Recent
Whirlpool 24 in. GU3200XTP Built-in Dishwasher - Page 3 Questions & Answers
This dw is not cleaning tea stains off cups. My
Hi,
I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works like new... However I have also foundthat if the heating element goes bad then that also can mess things up bad...So I would buy new spray arms, and also check out the heating element to makesure it is working... Here is a tip that will help you with the onlinebuying...
Dishwasher
SprayArms not Spinning
How to Buy
ApplianceParts OnlineA bad heating element causes many problems in dishwashers...
Dishwasher Problems The
HeatingElement not WorkingDishwasherMaintenance
DishwasherResidue and Film on Dishes
heatman101
Asker's Testimonial "explanation very clear. will give it a go and see howsimple it was. thanks Ronnie " - ronnieshomes
Our dishwasher started smelling like
Make sure there isn't any plastic on the heating element. Also check to see if there is any evidence of previously melted plastic. If it smells like plastic burning & you aren't using any heated options, cut the power & call for service.
Some lights are flushing and the dishwasher does
Hi,
If the clean light is flashing it is an indication of the water not heating up. I have attached a link to a sheet explaining what might be causing it and how to reset the control so you can use the dishwasher again.
Clean light flashingIf other lights than the clean light are flashing that is an indication there is a short circuit in the keypad control and that part would need replaced. Let me know if you need details on replacing that. If so I would need the complete model number from the tag on the dishwasher just inside the door.
The dishwasher will not do anything. The normal
what does the lcd show it says this -- in your post ? or is that all it shows is two dashes first thing to try is hold the cancel button for 5 seconds and then message me back with what the lcd shows i await your reply Thanks Rick
I am getting a white
If you have hard water, glasses can look spotted and cloudy even after cleaning. Sometimes changing the dishwasher detergent can help. The easiest solution to clearing up glasses that start to look cloudy is toadd some vinegar to the bottom of the dishwasher before you start a cycle. Simply add 1 cup of white vinegar and it will clear up your glasses very well.
You should see marked improvement after the first time you do this. If they are not crystal clear then simply repeat the process until all of the cloudiness is gone. In fact I recommend to using a little vinegar in each cycle to maintain the clarity of the glass.
Note: you can pre-test this by rubbing some vinegar on an individual glass with a cloth. If you cannot remove the cloudiness by soaking it and rubbing vinegar on it then it is possible that the glass is etched due to harsh or cheap dishwasher detergent and vinegar will not solve the problem.
Heated dry and normal led's flash and the machine
Hello....
your answer just might be at your finger tips. Check inside of the toe plate....located in the front outside lower half of the dishwasher. Should be held on by four screws. Inside there you will find a tech sheet that after you read it will tell you just what the lights are telling you.
If you cant locate one let me know and I will do some research for you ok?
just re-post if you need further assistance
Not cleaning very well.
Hi,
I
have an older dishwasher also and recently my wife also complained
about it not cleaning right... so me being the man I am tried in vain
to clean the things... Bought new spray arms online and installed
them in minutes...now the thing works like new... However I have also
found that if the heating element goes bad then that also can mess
things up bad... So I would buy new spray arms, and also check out
the heating element to make sure it is working... Here is a tip that
will help you with the online buying...
Dishwasher
Spray
Arms not Spinning
How
to Buy Appliance
Parts Online
A
bad heating element causes many problems in
dishwashers...
Dishwasher Problems The Heating
Element not Working
Dishwasher
Maintenance
heatman101
Asker's Testimonial "explanation very clear. will give
it a go and see how simple it was. thanks Ronnie " -
ronnieshomes
Dish soaps do not clean. Leaves a hazy film thats
Are you using a rinsing agent? What is your water supply? Is it well water or public water?
Please check to make sure that you are using a rinsing agent and that your hot water is hot enough for your Dishwasher to function properly.
The newer
dishtabs have both cleaner and rinsing agent in a balanced formula and work very well.
Is this a new problem? Or is it a new dishwasher? Did your manual say that it was okay to use vinegar in your dishwasher?
Good luck to you. If you do not have your manual, you can download one at
http://shared.whirlpoolcorp.com/product_literature/search_results.jsp?searchTerm=Gu3200XTP&siteCd=WHRCOM&userType=Consumer
You will need to use your entire model number as it seems there are several submodels to your number.
If these suggestions do not help you please reply to this answer for another look at the problem.
Good luck to you and thank you for using FixYa.
The clean light blinks 7 times
Hello & Welcome to FixYa
Flashing clean light is reset by pressing two buttons in sequence 3-4 times, to reset your kenmore press these buttons in sequence:
High temp wash-heated dry-high temp wash-heated dry
Please get back to me if you have any other questions.
Kevin
The clean light is blinking and it wont turn on
There is a malfunction and it is recommended to call for repair, tell them what is happening the manual suggests to call for service to check heater circuit. I am sorry if this is not much help.
Not finding what you are looking for?