20 Most Recent Kenmore HE3T Washer - Page 2 Questions & Answers

F dl = Door lock error
A Door Lock Error occurs if the door cannot be locked. It will try to lock
it six times before displaying the error code.
Possible causes/procedure:
¦ Door lock mechanism is broken or removed from door.
¦ Door switch/lock unit failure.
1. Unplug washer or disconnect power.
2. Check door switch/lock unit.
3. Check the wire harness connections to the door
switch/lock unit and Central Control Unit (CCU).
If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Water pump screen is plugged. Will not drain properly even though it goes into high spin.

The water valve had grit or sand in it, maybe calcium something to keep the valve from closing completely .

This machine is made by Whirlpool, It is the same machine as the Duet sport. Below I have included a link where you can download a copy of the service manual for this machine. Hope it helps. Click here to download the manual

Try un plugging it from the wall for 5 minutes or so then plug it back in to see if it works.

Sounds like the drum bearings have gone. This is a big job to do. If the machine is 5 years old and has done a lot of work, think about a new machine as may be cheaper in the long run.

Since we are working on the drain side of things only 2 things can happen to not get the water out of your tub-1 the pump isn't working,something stuck in it- 2 you have blockage which we know is not in the trap-check conection to the tub and the pump and all discharge hoses-cheers Denny

This should take 30 minutes: Remove the panel that is located below the front door, there are 3 small screws located at the bottom that hold this... you will see the water pump, which has a access screw plug. Unscrew this, its like a filter, you may see stuff, like coins, socks, etc, remove and clean out, then put everything back... this should fix the issue.

if you dont hear the motor then you have a control or power problem. if you hear the motor then you have a belt problem.

my Kenmore He3T Stop But Remain have water on the bottom!!!What happen