20 Most Recent
Northstar Pressure Washer 3000 PSI - Page 9 Questions & Answers
I can't get the machine
This is usually caused by either a plugged siphon line or if you are using the high pressure tips (red, yellow, white or green) on the wand. Check that the siphon line doesn't have any debris or bugs in it. The only way the siphon hose will work is if you use the low pressure, black soap tip on the end of the wand. The other tips cause too much back pressure for the cleaning solutions to be picked up by the hose.
I picked up my NorthStar
I would recommend that you call northern tool at 1-800-270-0810 and let them know what you need. I have found them to be very helpful and knowledgeable.Hope this helps you. Thank you.
I have a Northstar Pressure
This sounds like a mixture problem, try adjusting the main jet. You can also test by applying choke, briefly when you start to spray.
Runs good but presser drops
Disassemble the water admittance valve and clean bore with a dowel and crocus cloth. Then replace O rings on the valve plunger. Lube lightly with plumber's grease and re-assemble.
How do I adjust the
The following link will give you great troubleshooting for all pressurewashers.
http://www.pressurewasherservice.ca/serv02.htm
There are several way to increase pressure. Primary way is to turn the pressure regulator knob in the direction to increase tension on the spring. Pressure regulator is located on the pump (or very neer) and usually has a large spring.
Sometimes the spring is hidden under a twist knob. If the adjuster seems to be already turned to max then you may need to just change the pressure tip. The tip/nozzle is actually where the pressure is created by restricting the flow of water thru a very small opening. Use a new tip of the same gpm flow that is required by your machine. 18 hp machine has potential for very high pressure and high gallons per minute. Use trouble shooting guide
above for more information. Good luck
Not finding what you are looking for?