20 Most Recent Northstar Pressure Washer 3000 PSI - Page 6 Questions & Answers

If it really bogs down to where the engine is struggling....it's the carburetor. It's not allowing the engine the fuel/air ratio it needs for peak performance.

PDF]Owner's Manual - Northern Tool + Equipment

https://www.northerntool.com/.../1577544.p... Northern Tool + EquipmentCall NorthStar Product Support 1-800-270-0810 .... -During transportation take precautions to make sure pressure washer will not tip ..... A- Low oil shutdown.

If it is a twist coupler which won't turn, i use a pipe wrench or channel locks. If it's a quick coupler socket and the sleeve won't pull back, the quick coupler plug is bad. If you can't get them apart, both should be replacedTodd Lehkereplaced.

THIS SOUND LIKE YOU NEED A NEW SEAL

There will either be a drain plug in the side or on bottom of engine. you can also tip the engine and pour it out from the fill port.

most lawn mower shops can handle any repair on engine part of machine its the same engine thats on lawn mower , the pump well thats a bit more tricky , what i have done is remove it from engine and drain fluids and send it back to mfg for repair they send it back you install it back and put fluids back inside , whholla it works !!!

Sounds like the float in the carb is stuck. Take the bowl off, and check to see that the float is moving freely. Also check to see that the needle valve seat is clean - use a qtip or small wooden dowel to clean the seat.