20 Most Recent Konica Minolta Bizhub C300 All-In-One Printer - Page 7 Questions & Answers

A4 paper equals 8 1/2 x 11 paper wrong paper setting Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

What are you trying to reset?

Thread 2704 Abnormality in the black charging unit. Possible causes: Black charging unit HV Unit Print Control Board Best guess is that you have a faulty charge unit. Try swapping the units around with another colour and see if the fault code shifts.

Suction fan motor malfunction power off the on wait ten seconds between. check all the vents on the machine remove the covers where they are located and power on the machine check to see if they turn use can air to clean or get them replaced. Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

c0211 = Manual tray rise decent error - check PC14 lift up sensor, M2PC tray 2 vertical transport motor and also the tray 2 control board

yellow toner or motor Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Check the print head (s) for that that/those colors

Enter service mode -counter- parts couner-new release-select fuser-open front door-press start button. Exit technical mode. Good luck

try to install the driver again & be sure that is compatible with windows version

explain shaking???

Config Mode is depress 2 and 6 and power on. Diagnostic Mode is depress 3 and 6 power on. This is a Lexmark machine with a Konica Minolta logo

The fuser (The Hot Part) and the machine are not from the same region. For example: North America and Africa. Check where the machine is from and fuser came from. Try this once if it does not work contact a KMBS Technician: 1. Turn OFF the main power switch. 2. Turn main power switch ON while pressing the Reset key. 3. Touch [Trouble Reset]. 4. Check to make sure that [OK] is displayed and it has been reset. 5. After turning off the main power switch, turn it on again more than 10 seconds after and check if the machine starts correctly. If you do this to often you might cause a fire that will ruin a perfectly good day/ weekend!!!!!!!!!

clean thermostat

model number would help Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

if u installed ADF on Ur machine then check the ADF feeders if not .. then check scanner Assembly

• Suction fan motor malfunction - The fan lock signal remains HIGH for a predetermined continuous period of time while the motor

• Fusing Warm-Up Failure (Main) - The Fusing Roller Thermistor does not detect the required temperature within 30 sec.

P-21: Color Regist Test Pattern Failure; Secondary Transfer Atvc Failure; P-22: Color Regist Adjust Failure