Top 20
Jura Capresso Impressa E75 Espresso & Coffee Maker - Page 7 Questions & Answers
My BES 820 coffee machine on starting has only 2 lights flashing, the small hot water light and steam light.
All these home brew coffee machines are problematic in home use and this particular model was dropped from production, Try a power reset. Remove the mains plug for 5 minutes. Press and hold the Power button for 12 seconds, plug back in and continue to hold the power button for a further 12 seconds.
If that doesn't fix it, you will need a local Breville service centre to look at it with a view to installing a new control board f one is available.
Jura Impressa C5 all lights are flashing, Cant descale or clean. What do I do?
When all the lights on your Jura Impressa C5 are flashing, it typically means that the machine is experiencing a malfunction or error. Here are a few steps you can try to troubleshoot the issue:
- Turn off the machine and unplug it from the power source for a few minutes, then plug it back in and turn it on again. This can sometimes reset the machine and clear the error.
- Check the water tank and make sure it is filled to the appropriate level. If the water tank is empty or low, the machine may not be able to function properly.
- Check to see if the brew group is properly seated in the machine. If the brew group is not properly seated, the machine may not be able to start a brewing cycle.
If none of these steps work, it's possible that there is a more serious issue with the machine that may require professional repair. In that case, you may want to contact Jura customer service or a professional appliance repair service for further assistance.
Jura X5 Coffee machine stuck in heating mode
If your Jura X5 coffee machine is stuck in heating mode, it could be due to a variety of issues. The thermal fuse is one possibility, but it could also be a faulty thermostat or heating element. Here are the steps you can take to diagnose and potentially fix the issue:
- Unplug the machine: Before you start any work on the coffee machine, make sure to unplug it from the electrical outlet.
- Check the thermal fuse: The thermal fuse is located near the heating element and may be covered by a plastic sheath. Use a multimeter to test if the fuse has continuity. If it does not, then it needs to be replaced.
- Replace the thermal fuse: To replace the thermal fuse, you will need to open the coffee machine's housing and locate the thermal fuse. Remove the old fuse and replace it with a new one. Make sure to use a fuse with the same specifications as the original one.
- Test the machine: Once you have replaced the thermal fuse, reassemble the machine and plug it back in. Test the machine to see if it is still stuck in heating mode. If the problem persists, it could be due to a faulty thermostat or heating element, and you may need to seek professional help to repair or replace these components.
It's important to exercise caution when working on electrical appliances, so if you're not confident in your ability to diagnose or fix the issue, it's best to seek professional help.
Which brand to buy water dispenser for office and home.
- There are many brands of water dispensers available in the market for office and home use, and the best one for you will depend on your specific needs and preferences. Some popular brands to consider include:
- Avalon: Known for their sleek and stylish designs, Avalon water dispensers are a popular choice for both home and office use.
- Primo: Primo offers a wide range of water dispensers, including bottom-loading models, which are easy to refill and clean.
- Glacier Bay: Glacier Bay water dispensers are known for their affordability and easy installation.
- Honeywell: Honeywell water dispensers are popular for their energy efficiency and durability.
- Vitapur: Vitapur offers a range of water dispensers with features such as hot and cold water dispensing, as well as easy-to-use controls.
When choosing a water dispenser for your office or home, consider factors such as capacity, type of water dispenser (top-loading, bottom-loading, countertop), temperature options, and ease of use and maintenance. Additionally, read reviews from other customers to ensure that the brand and model you choose is reliable and meets your needs.
Brand new Lavazza Desea coffee machine - frother is losing steam around the head and not enough froth to make latte. Help!
1. Fill the water tank: Fill the water tank with cold water and make sure the tank is securely in place.2. Load the coffee beans: Open the top lid and fill the funnel with coffee beans of your choice.3. Select the desired program: Use the selection buttons on the front panel to choose the desired program.4. Start the machine: Press the Start/Stop button to start the machine.5. Wait for the desired coffee: The machine will grind the beans and dispense the desired coffee in a few seconds.6. Empty the grounds container: Remove the grounds container and empty it.7. Rinse the components: Rinse the funnel and the other components with hot water after each use.
Drip Tray stuck inside our Jura s8 coffee machine
To reset your Jura S8 coffee machine and remove the stuck drip tray, you can try the following steps:
- Unplug the coffee machine and wait a few minutes for the internal components to cool down.
- Gently try to wiggle the drip tray to see if you can loosen it from its stuck position. Be careful not to force it, as this could damage the coffee machine.
- If the drip tray is still stuck, you can try resetting the coffee machine. To reset the machine, you will need to locate the reset button or switch. This may be located behind the water tank, under the machine, or in the control panel. Consult the owner's manual for the exact location of the reset button.
- Once you have located the reset button, press and hold it for a few seconds until the machine resets. This may cause the drip tray to release and be able to be removed.
User manual for a crofton TI-CM-1013 COFFEE MAKER WITH THERMO JUG
Unfortunately, there is no user manual available for the Crofton TI-CM-1013 Coffee Maker with Thermo Jug. However, it is possible that the warmer plate can be switched on by pressing the "on/off" button. If this does not work, then it is likely that the warmer plate is not functioning properly and may need to be replaced.
Jura Impressa C9 Grounds container filling with water or Coffee. Grounds floating.
It sounds like there may be a blockage in the brewing unit or the drainage system causing the water and coffee grounds to back up and overflow into the grounds container.
You can try cleaning the brewing unit by removing it from the machine and rinsing it with hot water. Be sure to clean all the nozzles and crevices to ensure there is no blockage.
You should also check the drainage system for any clogs or obstructions, such as coffee grounds or debris. This can be done by removing the drip tray and examining the drainage hole at the bottom of the machine.
If these steps do not resolve the issue, it may be necessary to contact a professional for repair or servicing of the machine.
CVA-615 Seems to have water blockage before Brew Unit
If the hot water spout and steam wand are functioning normally, but there is no water coming out of the coffee spouts during the rinse cycle, it is likely that there is a blockage in the water pathway leading to the brew unit.
Here are some possible causes and solutions:
- Water filter: If your machine has a water filter, check to see if it needs to be replaced or cleaned.
- Water tank: Check the water tank to make sure it is properly seated and that the water level is sufficient.
- Water pathway: The water pathway from the tank to the brew unit may be blocked with scale or debris. Try running a cleaning solution through the machine to clear the pathway.
- Brew unit: If the above solutions do not work, the problem may be with the brew unit itself. Check to see if it is properly seated and clean. If it is damaged or worn, it may need to be replaced.
If the problem persists, it may be necessary to have a professional technician inspect and repair the machine.
The Neff C77V60N2/08 coffee machine does not turn on. There is a 220v voltage at the output of the machine's power switch.
The Neff C77V60N2/08 coffee machine does not turn on. There is a 220v voltage at the output of the machine's power switch.
If your Neff C77V60N2/08 coffee machine is not turning on and you are getting 220V at the output of the power switch, it is possible that there is a problem with the internal components of the machine. Here are a few things you can try to troubleshoot the issue:
- Check the fuse: The coffee machine may have a fuse that has blown, causing the machine to stop working. Check the fuse and replace it if necessary.
- Check the power cord: Make sure the power cord is securely plugged into the coffee machine and into the wall outlet. Check for any visible damage to the cord, such as fraying or cuts, and replace the cord if necessary.
- Check the power switch: The power switch may be faulty or not functioning properly. You can try to clean the switch or test it with a multimeter to see if it is working correctly.
- Check the heating element: The heating element may be faulty or not functioning properly, causing the coffee machine to not turn on. You can test the heating element with a multimeter to see if it is working correctly.
If these troubleshooting steps do not resolve the issue, it is possible that there is a problem with the internal components of the coffee machine. In this case, it is recommended to bring the coffee machine to a professional repair service for further diagnosis and repair.
Not finding what you are looking for?
