Top 20 Jura Capresso Impressa E75 Espresso & Coffee Maker Questions & Answers

The tap is the dial on the left turn it, then it will turn the tap off. If it is repeating this then it may need to be decalcified.

Jura Capresso... | 460 views | 0 helpful votes

Hi, I made a video how to fix your Jura step by step, good luck...!jura-coffee-machine/c15gy

Jura Capresso... | 332 views | 0 helpful votes

I have some good instructions I downloaded from . They are in German, but with many pics. If you are technically adept, then it is really no prblem. You should put in new o'rings and lubricate with the food grade silicon grease before reassembly, otherwise it won't be long before you are doing it again. Give yourself about 3 hours to perform this task the first time. One thing to remember. The cleaning tablets tend to strip the lubrication from the brew units, subsequently binding up the brew unit, sometimes tearing the o'rings and giving the malfunction 8. Plan on this being an ongoing maintenance exercise. Plan on at least once every year or two to have to do this.

Jura Capresso... | 1,786 views | 5 helpful votes

how fine is your grind set to if it is to fine the water will not be able to get threw ,

Jura Capresso... | 144 views | 0 helpful votes

Try using warm water in the watertank, important that the water is not too hot, it can cause leakage in the o-rings in the fluidsytem.
Repeat the procedure a few times, if nothing helps, turn off the machine and wait 1 hour and try again.

If you can`t get around this message, then the flowmeter needs to be changed.

Jura Capresso... | 2,077 views | 3 helpful votes

I have found seal/o-ring kits available on ebay Germany. Make sure you get the food grade lubricant to apply to the seals as well.


Jura Capresso... | 424 views | 0 helpful votes

I would remove the coffee spout and check the lines into it. The coffee seems to stop when it hits the spout and goes through the by pass instead. Remove the spout(be careful) then run a coffee and see if it works.

Jura Capresso... | 1,051 views | 0 helpful votes

I can help with this. I have become fairly well versed from owning two machines (an E-75 and an E-8) and having to repair them ocassionally. The guts in many of the Jura machines are typically very similar and utilize many of the same / similar components.
But it would be easier to handle via e-mail so that I can send pics of the inside of the machine and explain what's going on and what to look for. It will be much easier than explaining via this website. Just to alleviate concerns, it's most likely a simple o'ring issue.
I can be reached at


Jura Capresso... | 235 views | 0 helpful votes

Do you seem to end up with more water in the tray now then you did before this problem started? Does your coffee seem weaker then before? If so I have some ideas for you.

Jura Capresso... | 665 views | 4 helpful votes

I just called the company with the same problem today. They will fix your machine for free. They have recalled this machine. Call them and they will tell you what to do. 201-767-3999

Jura Capresso... | 373 views | 0 helpful votes

Malfunction 8 is related to the brew unit typically. It is usually an indication of the brew unit motor having to work too hard to move the brew unit up and down. This is usually cured by disassembling, cleaning, replacing any o'rings that may be bad, and lubricating the unit, then reassembly.
I have had to do this twice on an an E75 and an E8. I finally broke down and bought seal kits and lubricant for doing this. One could by a new brew unit off of e-bay and change out the whole thing. But a simple rebuild will typically suffice.


Jura Capresso... | 1,116 views | 4 helpful votes

Brew unit needs repair or replacement.

Jura Capresso... | 361 views | 0 helpful votes

kat346 There are a number of places were the leak could be occurring. I can't pinpoint it without see inside your machine. I maybe something like a broken or dried out oring or a cracked fitting or heater cartridge. We repair E75

Jura Capresso... | 542 views | 0 helpful votes

Open the drawer and take out the box for the grounds. Run a rinse cycle and it should now go back into place.

Jura Capresso... | 791 views | 7 helpful votes

check out this link:

Jura Capresso... | 1,931 views | 3 helpful votes

Fortunately the problem you describe is not model specific. All Jura machines in the series C, E, F, J, S & Z models have the same problem. The Jura recommended maintenance is insufficient or erroneous. Here is how it occurs:
1- When new machine is set up, the instructions advice the owner to set up OK for use of Filter cartridges. This set helps only to display reminders for replacing the filter.
2- The initial set up instruction also advises that with regular use of Filter, descaling the machine will not be needed. That is really not accurate. Consequently, the reminders for descaling are delayed for over one year or more. This causes serious consequence with accumulation of Calcium deposits in the entire hydraulic and coffee system.
3- Use of Filters alone does not prevent Calcium deposits. Cleaning tables recommended & sold by Jura do not remove Calcium deposits in the coffee/water passages. The automatic descaling method recommended by Jura leaves the coffee side of the machine unclean. The error message in your machine is due to Calcium deposits in the Brew group, coffee outlet & the faucet dispensing coffee in the cup. I suggest all Jura machine owners should manually descale machine. Manually descaling includes use of 6 to 10 rinse cycles with descaling solution in the water tank. The error message "Clean Machine" is accurate. This error message is pointing to descale the Brew group, coffee outlet tube and coffee dispensing faucet by using rinse cycles.

After the rinse cycles are complete, refill Descaling solution in the water tank & continue descaling the rest of the machine by using hot water dispensing function, ½ cup at a time until the tank is empty. Finally, give a final flushing of machine to flush out remaining descaling solution inside the machine.
Services Unlimited Inc Parts Guru Since 1988

Btw, I’m available to help over the phone in case u need at

Jura Capresso... | 255 views | 1 helpful votes

Error 5 is pointing to heating problem. Here are the parts that may be malfunctioning:
1- Thermal sensor not registering heating. Replace it.
2- Heater not heating up. Check continuity on heating element. If there is no continuity, (This is rare). Replace heater (Thermo block).
The problem can be linked to:
1- Missed descaling of machine for extended period.
2- Use of automatic descaling method suggested by Jura. Descale the machine every three months using Manual descaling method.. Services Unlimited Inc Parts Guru Since 1988

Btw, I’m available to help over the phone in case u need at

Jura Capresso... | 117 views | 0 helpful votes

Two to three teaspoonful water overflow after each espresso is normal. That is why the tray is there.

If water collection in the tray is excessive and programmed espresso is smaller, then there is cause for worry.

Btw, I’m available to help over the phone in case u need at

Jura Capresso... | 197 views | 0 helpful votes

Hi Shoba
Photo sensor or switch is blocked.
Not sure if yours is an Infra Red beam or switch
Clean & inspect with flashlight
Look for light path (blocked) or moveable part (switch)

Actually.... it must use an Infrared Light Emmiter to shine through the grounds holder to the sensor on the other side/

10 Minute Fix.... I hope

Jura Capresso... | 686 views | 0 helpful votes

Plug it in.............................

Jura Capresso... | 71 views | 0 helpful votes

Not finding what you are looking for?
Jura Capresso Impressa E75 Espresso & Coffee Maker Logo

41 questions posted

Ask a Question

Usually answered in minutes!

Top Jura Capresso Coffee Makers & Espresso Machines Experts

The Knight
The Knight

Level 3 Expert

76046 Answers


Level 1 Expert

40 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a Jura Capresso Coffee Maker and Espresso Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Impressa Jura Capresso

  • Impressa Jura Capresso

Most Popular Question

jura impressa e75 message mafunction 8

  • Coffee Makers & Espresso Machines