Top 20 Neff 24 in. S5453X1 Built-in Dishwasher Questions & Answers


Controller could be defective

Neff 24 in.... | 86 views | 0 helpful votes


There most likely is a problem with heating element or a wire shorting

Neff 24 in.... | 48 views | 0 helpful votes


Check the small round filter mesh, make sure its clean and that its not clogged. Use a degreaser on your machine then put it throught a hot wash to rinse it through.

Remove the bottom and top spray bar and inspect the spray holes and make sure they are completly un obstructed. Replace the spray bar and check that they spin freely. If they are not spinning well remove them again and check the mating surfaces for contamination and wear. if they are worn both the spray bay and their respective receptacles will need replacing.

Neff 24 in.... | 99 views | 0 helpful votes


I can't find any results for this error code. I would contact Neff's customer support line for assistance.

Neff 24 in.... | 427 views | 0 helpful votes


It is possible that the machine does not start off the cycle because there are errors or feedback from the inputs. For the program to start up the main program controller must initiate the INLET/PUMP MOTOR/DRAIN to work when it is commanded .If this does not happen then the voltage at these points must be checked or the fault relates to no voltage/drive from the controller. This means the controller is a suspect.

Neff 24 in.... | 1,133 views | 0 helpful votes


It is possible that the machine does not start off the cycle because there are errors or feedback from the inputs. For the program to start up the main program controller must initiate the INLET/PUMP MOTOR/DRAIN to work when it is commanded .If this does not happen then the voltage at these points must be checked or the fault relates to no voltage/drive from the controller. This means the controller is a suspect.

Check how to remove the control panel: http://www.espares.co.uk/advice/dishwashers/a/3/1287/how-to-replace-a-hotpoint-dishwasher-fascia-p.html

If the water flows then the flow should be good, if not the inlet valve is bad or there is dirt in the filter. Also check the flow at the inlet of the water line. What is most important for the motor to start functioning is that the door switch must be ON when the door is shut or this will be an error for starting the motor. The water pressure must be good and the spraying must be seen to be good. If there is low pumping or pressure then the spray arms will not turn around to inject with pressure. If so the pump must be checked for clogging.

Neff 24 in.... | 257 views | 0 helpful votes


If the inlet tap under the kitchen is ok and the water pressure is ok, then it is possible the water inlet valve in the dishwasher is faulty. you can locate the part on this diagram.

Neff 24 in.... | 697 views | 1 helpful votes


Hi
Dishwasher not draining issue usually occurs due to kinked drain pipe, clogged drain filter or drain pump. First make sure that the drain is not clogged and remove clogs if present. If no visible lint is present then remove the lower front access panel to check the drain filter and drain pump for any clogs, you'll need to clean the drain filter and drain pump completely. Also, check for any food pieces stuck near the pump impeller & clean the chopper assembly. Please note that dishwashers don't drain out the complete water such that heating element doesn't overheat. Hope this helps... Please post back for any further assistance.
Daniel

Neff 24 in.... | 280 views | 0 helpful votes


Most dishwashers kick on a valve to fill with water.
There's a float in there somewhere that triggers the shut off to the filling water.
Once water reaches this cut off level the pump should be throwing water thru the wash arms.

If base isn't filling to capacity...Id look to the drain valve.
If it fills to capacity and stops...the pump may be out or something is obstructing it.

Hope this helps...

Neff 24 in.... | 426 views | 0 helpful votes


The heater in the dishwasher might be faulty. Try running a quick cycle which does not heat water and check if the problem goes away.

The heater element can be found here.

Neff 24 in.... | 219 views | 0 helpful votes


Hi, this is most likely due to food waste stuck in the drain or the drain tube connected to the disposal. Remove bottom rack of dishwasher, then clear any debris from the drain located normally in the center. Be careful, many times I find broken glass in the drain. Next you want to check the drain line. Under the sink there is a flexible drain tube attached the the disposal or main drain stack for the kitchen sink. That is the drain for the dishwasher. Food and other things get stuck along the way and do not make it to the main drain and start stinking. Clean or replace the dishwasher drain tube.

Neff 24 in.... | 281 views | 1 helpful votes


Says here the overflow pipe night be blocked and needs to be cleared. When it's cleared if you still get a code "F" and it is still trying to pump dispite no water then remove the side panel and you will more than likely see you have water in the base. Remove the water and run the dishwasher with the side panel off and look for a water leak.

Neff 24 in.... | 356 views | 1 helpful votes


if the door is not closing do you mean will not stay closed this may be because of the locking hasp or the handle/lock located on the door on the top of the unit if the door is not moving up and down then this would because of the lower pulleys inspect your machine further and message me back with your finds Thanks again Rick

Neff 24 in.... | 397 views | 0 helpful votes


Hi,
Here is a tip that I wrote that will help you with your dishwasher not drainingproblem...

Dishwasher Problems - Water will not drain out

heatman101

Neff 24 in.... | 342 views | 0 helpful votes


Many dishwashers, due to their power consumption, are on their own house circuit. It may have blown the house fuse or circuit breaker. Ours does it about once every 6 months or so. I just reset the circuit breaker. I'm sure an electrician would tell me to replace the dishwasher or have it serviced to determine why it periodically blows the circuit, so if it has blown the circuit breaker, you should determine why before running it again (unlike me!).

Neff 24 in.... | 420 views | 2 helpful votes


Hi,


Here is a tip that I wrote that will help you with your dishwasher not draining problem...

Dishwasher Problems - Water will not drain out

heatman101

Neff 24 in.... | 210 views | 0 helpful votes


Looks like the heater unit has packed up.

I cannot seem to find the actual model you have anywhere on the internet. But I am assuming you connect the dishwasher to cold water inlet and it is meant to have a heater.

Are you in UK or Europe. Bosch also makes parts for the NEFF dishwasher but I am not able to find spare parts for your exact model.

Please post a comment.

Neff 24 in.... | 1,603 views | 0 helpful votes


Hi,
Here is a tip that I wrote that will help you with your dishwasher2_bing.gif not draining problem...

Dishwasher2_bing.gif Problems - Water will not drain out
http://www.fixya.com/support/r4078724-dishwasher_problems_water_will_not_drain

heatman101

Neff 24 in.... | 342 views | 0 helpful votes


Hi,
Here is a tip that I wrote about dishwashers and them leaking.

Leaking Dishwasher

heatman101

p80897

Neff 24 in.... | 214 views | 0 helpful votes


try stirring the water in the salt container. however, as long as you renew the salt now and again, it doesn't matter

Neff 24 in.... | 845 views | 0 helpful votes

Not finding what you are looking for?
Neff 24 in. S5453X1 Built-in Dishwasher Logo

76 questions posted

Ask a Question

Usually answered in minutes!

Top Neff Dishwashers Experts

Ekse

Level 3 Expert

13434 Answers

Marvin
Marvin

Level 3 Expert

85216 Answers

vince

Level 3 Expert

1234 Answers

Are you a Neff Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Neff Dishwashers

  • Neff Dishwashers

Most Popular Question

machine but water stopped coming

  • Dishwashers
Loading...