Question about Chrysler Sebring
...turn signal) switch or a bad combination flasher. With this particular vehicle, the flasher is an integral part of the multifunction switch. So, it can only be repaired by replacing the ...
...on link to see what flasher look's like. ...
Question about Chrysler Sebring
turn signal flasher that is bad. Good luck. i have the same problem and i checked all the fuses and they are all fine i think the flasher is bad and i dont know where its located. the only way to find
...turn signal does nor work. It flashes rapidly. I replaced the bulb and it still does the same thing. Is there a flasher unit under the dash that I might have to replace? make sure both signal lights ...
...TURN SIGNAL FLASHER LOCATED ON A 2000 Chrysler Sebing your turn signal flasher is located on the drivers side in the dash (Explaination) open the driver side door and look on the dash wherethe door ...
turn signal My left driver side turn signal is stuck on & I cant get it to turn off, this also does not allow me to use my right signal either. Where are the fuses for my blinkers?? They are not with ...
...turn signal flasher location The flasher itself is right beneath and beside the hazard switch. To get to it, look underneath the steering column, just behind the steering wheel. On the bottom of the ...
...turn/hazard signal bulbs? If so, which one. The backside of the bulb will turn about a quarter turn and come out the back side of the housing then you can change the bulb out as usual. should be ...
the turn signal or flashers don't work, where is the place to replace the part/ it is a 2004 Chrysler Sebring Check the turn signal/hazard relay in the engine compartment.
...turn signals work, right/left and front/rear, but left blinks at a very fast rate. This just started. Any ideas? Change the flasher which is located up by fuse block under dash A fast flash at the ...
1,852 questions posted
Usually answered in minutes!
965 Questions
801 Questions
581 Questions
462 Questions
523 Questions