SOURCE: Where is the fuse panel on a 1985 Ford Crown Vic located?
Local Ford dealership service department provide answer on location of the fuse panel. Fuse panel is located directly under the steering column. The cover panel is held by two screws and the power antenna swithch locking ring must be removed.
thank you all for you assistance,
SOURCE: Door panel on 1993 Ford Crown Vic
I just finsished working on this problem. There are three screws that hold the door panel on. One on the opposite side of the rear-view mirror. Another just below it (seen with the door open) and one in the middle on the bottom. When these three screws are removed, carefully pry the plastic trim from around the door handle. You can use a screwdriver. Then gently slide the panel up.
Good luck.
SOURCE: Wiper motor replacement for a 99 crown vic
I replaced the same part on a 1994 Crown Vic. There are a few bolts which go through rubber mounts on the firewall and that is how the wiper motor fits against the firewall. There is a clip on the wiper drive that must be pressed and slid off the wiper shaft. The hardest part was getting clearence between the engine and wiper motor. If I remember there was a way to turn the wiper case to clear the engine. I have asked myself why this was engineered like this? There is nothing important in the way that 3/4" of clearance could have been given for removal.
SOURCE: Replace horn on 2006 crown vic
I believe once you have mounted the horn and connected the wire you will find that the horn wire was cut at (by) the steering coloum that the siren override was hooked to,you will have reconnect this,I hope this helps you
112 views
Usually answered in minutes!
×