Jeep Car Audio & Video - Page 7 - Popular Questions, Answers, Tips & Manuals

Could be the light switch or the BCM. Try turning them on and off with the switch. If they go off, then the BCM is bad. Take the light switch off auto. O

You have to get a special solvent. You put it in the lines to flush them out. Make sure that you have removed the orifice tube. http://www.e38.org/pparish/flushing.htm

probably not-- you will have to see if there are the same number of stud holes, the same daimeter studs, the correct length of the studs, the same pitch circle diameter of the studs and the off set of the centre is the same

Remove cd player and insert small tool to release stuck cd. Otherwise dissassemble cd player and remove. Take to audio store and have them reome the cd.

blown head gasket or cracked block

Radiator fan will engage if engine is hot, if not, relay for fan or fan may be inop. Coolant sensor can also be in the coolant resevoir, and on the intake manifold area.

I'm sending you the diagram you need. If it doesn't show up go under Google.com and type in what you need.It'll show you everything you need

Google the translation. Consult with dealer.

No this means you can control Sirius radio with your car stereo, but you still require A sirius external device. In other words your looking for simply a Sirius add-on Kit for your stereo, If the kit comes with controller, which most do, then the fact your new car stereo is Sirius Ready, makes the Sirius controller obsolete. I hope this helps. Carlos Q

If you just purchased it from a dealer it should have a warranty for a few days. If it does take it back and let them deal with it. Could be cheaper in the long run.

Today's wheel bearings may be sealed within the wheel hubs on your vehicle. You will have to replace hubs which have wheel bearings inside, if this is the case. If bearings are sold seperately, it may be possible to install in the hubs.

Do you have a fault on the immobiliser possibly?

That light cannot come on by itself without the computer logging a code. See what the code is an post it here.

Thermostat may be inop, check/replace as needed. Waterpump may be inop, check/replace as needed.

Google may provide diagram you are inquiring about. Otherwise consult with dealer.

You must put a coil compressor on first, before removing the strut bolt. Serious injury or ***** may result if done improperly.

Speedometer inop, occurs if dash controls/indicators are damaged. ABS sensors may be INOP.

look underneath your glove box theres a cover, remove it and it would be there. thats were mine is

Do not touch metal surface areas of O2's. Oils from hands may cause errors or codes for sensors. Check circuit bank 1 with ohm meter to see if good.

googtrans fluid pressure sensor on 2004 jeep libertyle-