Amana Dishwashers - Page 5 - Recent Questions, Troubleshooting & Support

Does the light blink 7 times pause then repeat if so then there a problem with the heat circuit could be a bad heating element a wire off the element a bad thermistor or a control not outputing voltage to the element.

Is this a new dishwasher? Many only have a cold water connection. If not new, and it has used hot water previously, it is likely that the solenoid inlet valve on the hot side has failed closed. It will need a service call.

hnmmmm contact amana.

Junk in the pump, or debris may make pump wobble. GL

1- water intake is where water supply line is connected to d/w on bottom left be hind kick plate 2-remove spray arm and upper spray tube at same time turning to the right then you will have to use a torx driver to remove sump Cheers

check power connections at d/w power if ok replace concol

FIRST STEP IS TO CLEAN YOUR SUMP AND DRAIN FILTER AND PUMP CHECK FOR NPOISE AFTER CLEANING