Amana Dishwashers - Answered Questions & Fixed Issues

try a power rest. It that doesn't work, you need a service call as it is likely that the control board has failed. They are expensive so need professional diagnosis and warranty on the repair.

Why Your Dishwasher Isn't Working - Amana

https://www.amana.com > articles > why-your-dishwash... To do this, press either Start/Resume or Cancel, or open and close the door. Still not working? Reset it. Disconnect it from the power source for one minute. If ... ..

You have to hire a plumber.

Videos generically on the task. https://www.google.com/search?q=amana+dishwasher+remove+door& ..

http://www.fixya.com/support/t1368757-amana_dishwasher_door_will_not_open

http://s3.amazonaws.com/bobspdf/mn/e/1311039L.pdf

try detaching and reattaching the ribbon circuit make sure you use electrical grease

I agree. Sometimes is only a matter of cleaning it well and reassembling it. Of course, you may find missing or broken pieces while doing this. Look for a way to take it more apart (without breaking it). Have you pulled the unit out of cabinet yet? The access you want might be under the insulation.

Sounds like a control board problem

Spray TILEX mold and mildew cleaner inside and then run a cycle with no dishes, use hot water cycle.. Why could be the municipal water has a high concentration of mold spores for some unknown reason.

The bore in the impeller is spun out. Mix some JB Weld and apply a liberal amount to the bore of the impeller, install it back on the motor shaft and rotate the shaft a 1/2 turn to distribute the weld before cure. Originally the impeller was a press fit. Don't allow food to get sucked into the pump, lock down and damage to the impeller will occur

Most likely get a flat head screwdriver and just pop it off.

What make and model number are you asking about?

How do you close the detergent door when the tablet is in

get a new heating element

replace motor or fuse

It could be a bad latch switch or a bad control board. Maybe a bad touch pad.

Check to make sure the door is closed and latched. Also check the water supply.

New problem or old problem? Has it ever worked? First check the main control component and make sure all wires are plugged in.

It is very likely the wash arms are clogged or the wash motor is not working. Need to open the sump and check for blockages. Please provide complete model number to help provide location of parts involved.

have you checked to see if the white and black (or hot) wires are reversed. It is very common to have this problem. some plug wires have a smooth edge and a rippled side, one wire per side and the ground wire is green or in the middle. if there is a side that has a rippled edge make sure that it is on the black wire of the dishwasher and the white to the smooth side. I remember this in this way: if i hook the power side to an oscilloscope it would show a wave pattern and if I do the same with the common or white wire then it is smooth a straight line