...minutes. 2. Verify that the fuser connector and thermistor connector are both firmly seated in the ECU 3. Perform a heating element resistance check. 4. If the resistance readings are correct, but ...
...the motor rotate, verify that connector J1702 and J1505 are fully seated on the DC controller PCA (ECU). 3. Verify that the connector J12 on the laser/scanner assembly is securely attached. 4. If
...in the device. 8. Verify that the memory tag connector is firmly seated in connector J510 on the ECU. You might have to remove the main cooling fan to see this connection. 9. If the error
...of a print job. 1. Verify that the scanner motor connector and the ribbon cable from the ECU are firmly seated on the laser/scanner assembly. 2. Verify that the scanner motor connector is ...
Question about LaserJet M3027x MFP Printer
...Any suggestions? 1. Verify that the laser/scanner motorconnector and the ribbon cable fromthe ECU are firmly seated on the laser/scanner assembly.2. Verify that the laser/scanner motorconnector ...
...bent. Finally, make sure that the memory tag connector is fully seated at connector J1703 on the ECU. The connector is behind the main cooling fan so it might need removed to check the connector. ...
Usually answered in minutes!
1,429 Questions
1,001 Questions
724 Questions
663 Questions
593 Questions