Questions & Answers for: ecu seat

Ad

Question about 1992 Accord

2 Answers

...under drivers seat. Hi! ECU is located behind right side of dash on Accord. Also refer this link for your refrence, as you would need it --- ECU Connections Please rate this solution. Thanks ...

Ad

...changed the power tr unit , one plug sparks once Given tha age of the car could very well be a bad ECU, Engine Control Unit. Early 90's mitsubishi's had poor capacitors in the ECU and tend to leak ...

Ad

...seat ecu. under drivers seat. progressive power steering ecu. behind left dash left of column. Steering column tilt + telescopic ecu. behind left dash above column. Anti-theft ecu. behind far left of ...

...equipment connected to the data link connector of the car, even you had repaired first fault wires cut under seat! After all faults erasing from the Airbag ECU the airbag warning light will turn

Question about LaserJet P3005 Printer

1 Answer

...of a print job. 1. Verify that the scanner motor connector and the ribbon cable from the ECU are firmly seated on the laser/scanner assembly. 2. Verify that the scanner motor connector is ...

Question about LaserJet M3027x MFP Printer

1 Answer

...Any suggestions? 1. Verify that the laser/scanner motorconnector and the ribbon cable fromthe ECU are firmly seated on the laser/scanner assembly.2. Verify that the laser/scanner motorconnector ...

Question about 1985 Accord

2 Answers

...seat is where the ecu is located honda no fuel relay on the carb model should be a mechanical pump mounted up on the intake strange looking critter fuel pump should put out about 3-5 psi fuel ...

...ECU?..Thanks,Scott There have been a lot of times that vw has put the wires running under the carpet on the pass side under the seat and everything I have had similare problems and had to remove the ...

...ecu for manual seat operation ECU has failed and would like to use manual operation for front seats. The seat has the heater relay in the spare slot the manual mentions. How is it achieved in the ...

...of a print job. 1. Verify that the scanner motor connector and the ribbon cable from the ECU are firmly seated on the laser/scanner assembly. 2. Verify that the scanner motor connector is ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

john h

Level 3 Expert

22486 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...