I cant find ssid while installing hp deskjet 3050, how can i find wireless network name?

yes
you have to check and adjust compatibility and have the correct driver installed

The SSID is the name that is broadcast by the wireless router to identify the wireless network(s). Most devices will perform a scan and provide a list of detected wifi networks. The names you see on the list are the SSIDs. It is possible for a wireless network to exist but not broadcast its SSID. In those cases you must manually enter the SSID in order for the device to scan for, locate, and attempt to connect to the wifi network.

hi change the cable its may be damaged

Please use the utility disc that comes with your printer. It will help you to connect your printer to your wifi router.

Or please check if you type the correct SSID of your wifi (Wifi Name). SSID are case sensitive.

When you installed your wireless router, you should have configured its wireless interface:
* set an SSID -- the "name" of your network
* set an encryption-level -- hint: use 'WPA' or 'WPA2'
* set a password or pass-phrase for your network

Enter the SSID/password on your HP printer, to connect it to your router.

You must first connect your printer to the pc using usb cable, then run installation wizard that is on the CD that came with the printer.

Wizard will guide you through the setup orcess where you will provider your routers ssid (linksys) to your printer, and your printer will use that ssid to connect to your router.

After the Wizard setup is done, it will tell you to disconnect the usb cable and only then your printer will work on wireless.

Good luck,
Milan

Scan foir the wireless network on the laptop and connect to the network:

1. Go to 'Control Panel', Click on Classic View in the left hand side menu and then open 'Network Connections'.
2. Right-click on the wireless Network Connection icon and select 'Properties'.
3. Click on the 'wireless network' tab.
4. Under Preferred networks if you see any name in the list then highlight the name and click remove.Click OK.
5. Right-click on the wireless Network Connection icon and select 'View Available Networks'.
6. Look for the SSID (aka Network Name) of the Wireless router or access point.
4. Highlight the SSID from the list that you want to connect to.
5. Type the security Key here and click on the 'Connect' button.
6. You should have successfully established a wireless network connect

do you have the program disc if you do then inset it to the computer and hit restart installation and then follow the steps but make your you know your router name (SSID) first.

Bring up the status display showing the wireless networks sensed by your computer. The SSID that you want is the one that your PC is connected to.

You can see the SSID name from one of your wireless computer that is already connected to the wireless network. Just point your name over the wireless little computer icon down at bottom right hand by the time. It will say there "Wireless Network Connection, Connected to "name of the network". That "name of the network" is the wireless signal name like "Linksys" or whatever name you gave to your network when you setup the router. That's the SSID name as well. Wireless Network Name = SSID.