My matag washin machine worked perfectly on a cement floor we moved it into a tile floor and it shakes all over the place it tried to level it but it still shakes

Most glue will stick to vynil tile however it is recommended to flash the floor with a b Portland cement leveler and make sure loose tiles are glued or filled

tiles on wooden floors will always move and crack the grout/tiling cement
therefore the rubber membrane goes down first with out nails and then everything is laid on top
that way when the wooden floor moves , there is a water proof membrane to prevent the water from rotting the wood over time

there are two causes to this problem.1 at the top of the machine is a balance,cement brick [it may be broken]it balances the drum.2 adding a small load/ie;one towel;one item etc,or small items.adrian,,,,,

If your transport bolts are removed and if the springs or shocks are in good order, make sure the machine is not standing on a tiled floor. No matter what, it will bounce all over the floor then. Place machine on a concrete floor and retry.

All front loaders shake to some extent. It depends on the balance of the load. It is especially evident in the spin cycle due to the high speeds. Also these machines are best placed on a solid cement floor. They can shake an entire house if on the first or second floor and the floors are not well reinforced.

Sounds like there is an isolator broke within the unit, this can be either a sring or shock type of connection.

your problem may be in the shocks or because this machine is very powerfull and spins very fast that the floor is giving (has play) and needs to be supported up from underneath it if u put the machine on a cement floor lock the legs securly to the machine if it spins fine then your floor is the problem
if it still shakes then i would replace the shocks
(sol v ya prob)

Ensure the washer is level by rocking it. If its level should'nt be able to move. You may have a weak floor. to checks this look to see if anything is vibrating around the washer.

You can get a crack membrane to put over the cracks. First use a primer on the floor, this is a primer just for this application, then put membrane on top of primer. these products can be found at home depot or lowes or any tile store.Also do not use cheep thinset. the better thinset is more flexible and will absorb any movement. The cement board would not work as they will move or flex and cause the grout to crack and tile to loosen

tom

you need to have all the equipment and goods. The tiles, cement to fix them, the cutter, a level, a rubber hammer, a marshy, a water drum, and paper.
1. use the paper to cover all the area that may be damage.
2. level the surface
3. put the title in the level floor, without pasting them, and measure the titles you need to cut, to fix all the are, measure and align them.
4.with the marshy apply the cement to the area
5. Put the titles and with the robber hammer hit them softly.
6. went finish clean them with a soft rag and water.