SOURCE: jacuzzi bath
Many time leaks around pumps are a simple o-ring that needs to be cleaned and/or tightened. If the jets are leaking from the back side then the jet will have to be removed and resealed.
Good Luck, Phil
SOURCE: whirlpool bath won't turn on.
Most of the control buttons on a tub are not electrical. These buttons are connected to an air line that runs to the motor. Sometimes an aggressive button push can literally blow the air line right off of the bottom of the button.
This problem is as easy to fix as it sounds. Find the loose air line and push it back onto the button. You will need to open up your access panel. Bring a flashlight.
Be sure to check the connection at the motor too. Good luck
SOURCE: The stopper of my Jacuzzi
Try this link. I hope it can give you the info that you need:
http://www.ccowhirlpool.com/web-pdfs/Jacuzzi_Whirlpool_Bath/TroubleShootingGuide.pdf
SOURCE: We have a jacuzzi corner
Hi,
According to your problem check all water passing areas. You have to check the pump, the channels of water passing. Check the jets may there is any fault. If there is any problem then repair or replace is recommended. Repair the leakage of pipes. You can also try to reset the control panel.
182 views
Usually answered in minutes!
×