Top 20
Canon PIXMA MX850 Multifunction Printer Questions & Answers
Can't change paper source
when you go to print you should get a print page on which you will see properties
click on that and select the tray you want to print from
make that tray the default tray-- apply ---and ok
Correcting B200 Error
1) The Support Code b200 is an error message that may arise with the text which states "Printer Error Occurred", or "Contact the Service Center".
2) You will receive this message on your printer due to an electronic problem which may arise in the ink cartridges.
3) Open the top cover of your printer. Discard all the cartridges. Get rid of the printhead by lifting the lever which is placed just near the cartridge cradle, then take the printhead from the printer.
4) Re-insert the printhead back into its correct position, and ensure to lock the lever. Insert all the cartridges into their correct position, and confirm that there is no open door.
5) Unplug your printer cord from the electricity board, and keep it unplugged for a few minutes.
6) Let the printer cool down. Plug the printer back again.
No lights on the ink cartridges, error b200.
1) Turn the printer off. Unplug it from the power source. Open the printer cover in order to expose the ink cartridges.
2) Remove the MP560 cartridges - PGI-220BK and CLI-221. Re-install the printhead, and the ink cartridges before you power up your printer.
3) Cleaning the printhead might solve the problem.
Drivers
Try this link for Drivers to download.
http://www.usa.canon.com/cusa/support/consumer/printers_multifunction/pixma_mx_series/pixma_mx850#DriversAndSoftware
B200 code on a Canon MX712
cns assoc's answer was spot-on. I found the burnt-out nozzle under an empty cartridge, which I tried to take a picture of...
Cyan color does not work
Is there ink in the cartridge?
If so you may remove the print head and take a mixture of 1oz. ammonia and 8 oz. water (roughly 180 degrees) and let it soak for 30 minutes.
If you see some cyan ink come out you are on your way.
Now completely dry the head being careful of the nozzles.
I usually use an air duster can to blow off and let stand for a few minutes.
Good luvk.
Where can I get a Parts List for a Canon MX850 MF Unit
Ink Absorber Full
This may
clear the ink absorber problem.
There is ink absorbers located at both ends of the printer
where the ink head move.
To dry the ink absorber, power up the printer and open the cover so the ink
cartridges and print head will move to the middle of the printer.
Then take several sheets of absorbent tissue, fold it into a pad and place it
inside the printer over the ink absorber on the far left hand side of the
printer to soak up the excess ink. You may need to change the absorbent tissue
a few times. Then repeat the same procedure on the right hand ink absorber.
Close the lid and the printer should now function normally.
Not finding what you are looking for?