...timer is out of sync with the cycle. About a week ago it gave off a burning smell. But it stopped and worked fine until today. Any suggestions? You have to investigate where the burning smell came ...
Question about Washing Machines
washing machine w74 timer has 2 motors on a single shaft. Do they ever get out of sync ? if so how do you get them back normal? i have 2 machines that will go thru most of its cycle but when they come
Washing machine keeps wanting to fill up whilst in a programme There could be a problem with the control board or the timer. The control board and the timer are not in sync so either one could be a ...
Question about Washing Machines
...valve not shutting off properly? all draining is done with the water pump and that is working could be faulty water level solenoid / valve but I suspect washing machine timer out of sync /control ...
...timer is running behind then the clock might be out of sync with the processor controller. Check to see if the motor is free, the capacitor is good because the fault can also occur due to a load shut ...
washing yesterday with no issues. I then put on a third load, pressed start and walked away. 45 mins later I heard it beep so went to look and it was showing error E20 which my manual says means there
...timer, How do I reset and sync the brains After 2 more sears repairmen. They replaced, motor control unit. Wrong.. Then the computer control board.. Correct.. Did not wait for the Repairman because ...
...machine; . i opened and checked the timer and found the synchronous motor has failed( no continuity in the motor terminals) The marking on the synchronous motor is -M001 3ws. I do not wish to change ...
...Washing Machine Timer Out of Sync Our Kenmore washer has had an intermittent problem with the timer dial stopping right before the rinse cycle. I would go to check the laundry and the tub would be ...
The washing cycles are out of sync with the control knob. My experience is that part of a gear is strip (there ia a few gears in that "timer"). possible cause is that it was turned the wrong way
185 questions posted
Usually answered in minutes!
2,979 Questions
1,498 Questions
358 Questions
175 Questions
151 Questions