Frigidaire FAC127S1A Air Conditioner "relay board" Questions

...board? If they are mounted to the board, you will need to replace the board. Sounds like you are getting a call to the relay but none leaving so this would indicate that you have a bad relay

...bad. In your caee the relay is stuck and you can tap on the relay to shut it off but eventually the board will need to be replaced. The relay is part of the board so the entire board must be

...RELAY. NOT ALL RELAYS ARE ON THE BOARD.. THE BOARD ALSO CONTAINS RESISTORS AND SWITCHES CALLED LIMIT SWITCHES AND ROLL OUT SWITCHES. MOST ARE SOLDERED BUT ALL RELAYS ARE NOT LIMITED TO JUST THE

...board then to relay to connect 12 using electrical schematic of unit(in plastic bag near ele. box) and ele. schematic on side of old relay and schematic on new relay attach new relays so each ...

...relay on the board, that is one thing.  If you are qualified to do the work (desoldering and soldering and check out) then go for it.  If you are talking about replaceing the board with a ...

...relay unless you know how to read wiring diagram then you can use a 90-340 generic fits all replacement. trace motor power wires back to relay or control board to find where they are fed

...board, pry off upper rear relay plastic cove, remove spring and stretch it out just a little from its original length because the relay is either getting weak or there are other problems with the ...

...I have 120VAC to the board but not on the card edge that goes to this fan. How is the relay energized? Fan relay is on the PC board. Is the LED on the board registering the call for heat by

...is a electronic ignition Furnace the relay is located on the intergrated control board. The only problem is that you cannot replace only the relay on those boards, the whole board must be

...need a new board.  After replacing relay or board, I would recommend that you amp the circuits to ensure that a component is not defective or going bad which may have caused the relay to