Cannot remove spare tire from undercarriage - 2008 Chevrolet Uplander

SOURCE: How to remove the spare tire on 2001 Chevy Blazer

if the vehicles spare is located under the rear cargo area then there may be a hole located in the rear bumper next to the license plate. if the vehicle is equipped like that then there should be a few straight bars that attach together to form a long bar. this bar is then inserted into this hole and mated with a joint witch is connected to a pully system that raises and lowers the tire. if this didnt make any sense or if it is totally wrong then you could consult the owners manual. all of the necessary procedures are in that book.

SOURCE: spare tire removal

If the tire does not lower with the jack parts from the access door then you will have to put the jack up under the presseurerelease in the middle of the tire till it releases.

SOURCE: How do I remove the spare tire

lift open the tailgate..lift the panel that is in the back there is a nob that is covered by some fabric..use the jack that comes with the truck it has a diagram underneath the panel of how to lower the tire and release it. i had the same problem the first time i got a flat as well. after you figure it out it is very easy and simply replace the bad tire with the new.

SOURCE: unloading spare tire 2005 trailblazer

After you open the rear hatch look on the sill of the frame on the right hand side of the truck. You must insert the Jack crank into the hole and turn it counter clockwise to release the holder and the tire will tilt down from underneath. If it does not release then you may have to pull it down as the mechanism has been known to seize. After you open the rear hatch look on the sill of the frame on the right hand side of the truck. You must insert the Jack crank into the hole and turn it counter clockwise to release the holder and the tire will tilt down from underneath. If it does not release then you may have to pull it down as the mechanism has been known to seize.

SOURCE: how to remove spare tire

there is a hole witch is probably covered by plastic on your rear bumper. look and you should see a square drive shaft. place your spare tire kit arm on it and tun counter clock wise and your spare should slowly start dropping to the ground. hope this helps and god bless.