20 Most Recent 2008 Chevrolet Uplander Questions & Answers


the only way to turn off the traction control is to remove the fuse for it in your fuse panel. if the light is on that is usually a sign that you have a bad abs wheel speed sensor. and it just needs replaced. http://www.youtube.com/watch?v=cX0FsAzuuic

2008 Chevrolet... | Answered on Jun 14, 2019


Check the fuse block for a blown fuse. There may be a solenoid inside the transmission that finally gave up. Look for poor electrical connections on the wire harness at the transmission and finally, the transmission control module may have failed.

2008 Chevrolet... | Answered on May 04, 2019


Check fueses and relays in fuse box.Look for blown fuse for compressor. Do not over fill with freon it will lock up compressor and don't forget the oil for compressor.if it's in red let some out in your recovery tank.if you have one wink.wink. the relays are big and grey you can switch with one of the others with

2008 Chevrolet... | Answered on May 02, 2019


No recall . Reduced engine power is caused by a problem with the electronic throttle control . Having the vehicle checked for DTC'S - diagnostic trouble codes would point you in a diagnostic direction . Viewing videos on how the system works an testing would help .
https://www.youtube.com/watch?v=Z34r2Fra7ig&t=806s

2008 Chevrolet... | Answered on Feb 11, 2019


This repair is tedious. You will find the thermostat housing located directly below the throttle body. It is tightly set between the engine block and exhaust crossover pipe. There are two bolts holding the housing in place. The lower housing bolt is the hardest one to remove so remove that one first. Any questions please write back. Good Luck.

2008 Chevrolet... | Answered on Nov 03, 2018


i have an 2007 chevy uplander flexfuel i keep getting p1174 also i have replaced the the o2 sensors and the light keeps coming on
i belive it has something to do with the fuel injection system

2008 Chevrolet... | Answered on Oct 25, 2018


Michael, this job requires special tools. You need to recover the refrigerant. But your big issue will be removing all of the moisture from the system, after the compressor surgery.
System oil is another major concern. As per directions, measure that you remove from the compressor. Adjust accordingly. Meaning for example, (Random values, check specs for your system) if you were to have 4 oz of oil in the compressor, but you find only 3 oz (measured!), you are not down 1 oz. The entire system is 25% low on oil. Adjust accordingly. No biggie, but if you are not aware of these things, you will introduce moisture into your system, which will react negatively with the metal parts of the system, causing costly damage.
Always replace the receiver/dryer when you open an A/C system.
(it has oil in it, too...)
Really, dollars and cents, this job might want to be done by a trained professional.

Discharge of refrigerant is ******* most everywhere.

Doc

2008 Chevrolet... | Answered on Aug 08, 2018


Can someone send me a video or diagram where the2002 chevy trailblazer LS fuel lines fo

2008 Chevrolet... | Answered on May 18, 2018


DTC P0499: Evaporative Emission System Vent Valve Control Circuit High
  1. Sensor or solenoid faulty
  2. Connector terminal contact damaged or corroded
  3. Wire harness fault - Check for correct voltage, open, short to ground or short to voltage
  4. Update control unit software - Check for the latest control unit update
  5. PCM or ECM faulty
  6. EVAP system - Check fuel cap, canister, valves and components

2008 Chevrolet... | Answered on May 17, 2018


Sounds like you've got two different problems, because the brake lights and turn signals are on different circuits.
1. Brake lights. These should work whether the engine is on or off. Check fuse box for a blown fuse. If OK, check for voltage at one of the lights with the brake pedal depressed. If no voltage, brake light switch under dash probably bad. Fairly easy replacement.
2. Flashers/turn signals. The flashers should work with the engine on or off. If they don't, might be a bad fuse. If that doesn't fix it, might be a problem with the wiring connected to the turn signal switch, or the switch itself.

2008 Chevrolet... | Answered on Feb 09, 2018


Sorry, but I do not understand what question you are asking. Can you please be clearer.

2008 Chevrolet... | Answered on Jan 03, 2018

Not finding what you are looking for?
Cars & Trucks Logo

437 questions posted

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85020 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Uplander Chevrolet

  • Uplander Chevrolet

Most Popular Question

2008 chevy up lander driving down road

  • Cars & Trucks
Loading...