20 Most Recent 2006 Chevrolet Uplander Questions & Answers


As any earlier answers there is fuse 23 and 25 however there is also a fuse behind the lighter which is not replaceable. You can use the factory replacement or the hole it's too big for aftermarket. Hope this helps

2006 Chevrolet... | Answered on Feb 04, 2019


No , they use different fuse's . FRT/BLWR fuse # 27 - 25 amp , RR BLWR fuse # 28 25 amp . both are located in the under hood fuse box . But the odds of this being a fuse problem are astronomical . Unless there is a electrical short circuit on that circuit . You may replace the fuse an it mite work , but for how long .? The blower motor may be going out an drawing to much current . Do you know anything about automotive electrical ? Amps , volts , resistance ? How to view a wiring diagram to see what all is involved in the blower motor electrical circuit , how to use a DVOM - digital volt ohmmeter to test electrical circuits etc .... ? Plus - do you know if it has a manual or automatic climate control system ? It doesn't work on any speed ?

2006 Chevrolet... | Answered on Jan 28, 2019


There are 2 6 cylinder engines for that year. Both are the same as far as wiring/firing order but gave you both anyway(see below). There have been times that I thought I did the same thing as far as the firing order and have been doing it for 25+ years. Sometime i did and sometimes I didn't. So if you find the wiring is correct and you seem to have a miss, In about 90 percent of the time that this has happened to me I had knock a vacuum hose off so you might want to start there if they are right. It sure sounded like a miss at those times but was vacuum. There are other factors but that's where I would start if this is the case. I hope this helps and good luck.


clifford224_202.jpgclifford224_203.jpg

2006 Chevrolet... | Answered on Jan 23, 2019


2006 Chevy Uplander, I don't see LTR anywhere. This is usually an easy find for me.
1_10_2019_10_51_34_pm.jpg

2006 Chevrolet... | Answered on Jan 10, 2019


THE ENTIRE DASH HAS TO BE REMOVED

2006 Chevrolet... | Answered on Jan 10, 2019


Hi. I read your request and it isn't possible for me to tell you what your car needs from your description. Your vehicle is 12yrs old and if it has around 200K miles on it. It may be time for a replacement transmission. This suggestion is based on average transmission life span for a Uplander. The life of the drive line can be greatly extended with consistent, on-time preventive maintenance. Does this apply to you? How is your transmission maintenance history? Is the fluid the proper level and red in color? has the engine turned on or started flashing at all? If so have you had any of the codes read? Please have the codes read if this applies. This situation usually requires diagnostics to find out what is wrong with your car's transmission and speedometer. Shutting the engine off and restarting it may help but issn't enough for a diagnosis. The speedometer also requires diagnostics. With this issue more than likely the fault will either be a bad output speed sensor, broken wire, corrosion on plug/terminal or the gauge cluster itself will need to sent out for repair or be replaced. Please write back and give some back ground on your experience and tools you might have for performing diagnostics. For example line pressure and a multimeter to look at wiring and circuit operation.

2006 Chevrolet... | Answered on Nov 14, 2018


I have a chevy uplander and you have to open the passenger door and its on the side of the dash, to the right of the glove box. You will notice a small rounf opening with just enough room for 2 fingers to go in. the whole side will come off when you pull it.

2006 Chevrolet... | Answered on Nov 10, 2018


i have a 2006 chevy uplander and i need to change the low beam headlamp how do i do it, also about a month after we had got the van the rear wiper stopped working i haven't checked the fuse yet, but is this a common problem for the uplander, and also the abs light stays on what should i do for that problem, and also when we drive it and then shut it off it does not want to turn on right away.

2006 Chevrolet... | Answered on Nov 10, 2018


Clean the light sensor in said the player it is dirty and can not read the disc,all the best.

2006 Chevrolet... | Answered on Nov 04, 2018


Can you elaborate on the shake? A "Shake" could be low idle, vacuum leak, low fuel pressure, timing, misfire, cylinder compression, torque converter clutch or another engine or transmission related failure. How does the vehicle idle and rev in park? Is the engine light on and if so were any codes pulled? how is the maintenance? How does the engine oil and transmission fluid look? Are the recommended services up to date? An over due tune up and fuel service can cause these issues. a restricted transmission filter and low or worn out transmission fluid will cause transmission problems. Please write back but provide all the info you can. I'm not there so I need to see what you see. Also give me an idea of what you want. Some people are not able to perform diagnostics and only want a quick fix, if possible. Other are more experienced and want a schematic or helpful diagnostic tips.

2006 Chevrolet... | Answered on Nov 03, 2018


Is this v6 vin L? If so,
1st step--44 ft lbs
2nd step-- turn additional 140 degrees.
Do you need torque sequence?

2006 Chevrolet... | Answered on Oct 25, 2018


3.5 L engine is 0.040 in. gap on all spark plugs

2006 Chevrolet... | Answered on Sep 21, 2018


after putting some gas in your tank, step on the gas pedal repeatedly (step to it fully), then while pressing, start your car. the fuel was completely drained from your system thus there are no fuel to burn in able for your car to start.

pressing the gas pedal repeatedly (around 10 times will do) will put some fuel in your combustion chamber, so the car will now have something to burn if you will start the car

2006 Chevrolet... | Answered on Sep 21, 2018


What are all of your symptoms?
1 bulb or all?
Front and back?
Help us help you.....
Dean

2006 Chevrolet... | Answered on Sep 19, 2018


You need the theft deterrent code, you can buy it online and or the dealer can look it up for you

2006 Chevrolet... | Answered on Sep 19, 2018


Doesn't have a flasher , the BCM - body control module turns the turn signals on an off .
Turn Signal Lamps
The STOP/TURN fuse in the instrument panel (I/P) fuse block supplies battery positive voltage to the body control module (BCM) for the turn signal lamps. When the turn switch is placed in the left or right position, ground is applied to the BCM on the left or right turn signal switch signal circuit. The BCM then applies voltage to the appropriate front and rear supply voltage circuits.
Grounds for the various lamps are as follows:
• G100 supplies the right front lamps
• G101 supplies the left front lamps
• G400 supplies the right rear lamps
• G401 supplies the left rear lamps

2006 Chevrolet... | Answered on Jul 30, 2018


About all I can help with is voltage and ground. The voltage is fuse protected, check the fuse and voltage on fuse circuit. If you think problem with ground, try a redundant ground. The text below is a little small, hope you can read it? bbbind.com should have your wiring diagram for radio. It's free.
radio-u21t4mpnezjefjsjyk2glyun-4-0.jpg

2006 Chevrolet... | Answered on Jul 02, 2018


Seems like all the answers here are for front vents.... the author has a REAR vent problem......

2006 Chevrolet... | Answered on Jun 30, 2018

Not finding what you are looking for?

757 questions posted

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

83959 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22441 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Uplander Chevrolet

  • Uplander Chevrolet

Most Popular Question

front heater blower quit 2006 chevy

  • Cars & Trucks
Loading...