20 Most Recent 1993 Ford Aerostar Extended - Page 3 Questions & Answers

In hot weather i would use 10w/40 good luck to ya, In colder temps need a weaker oil because it's thinner and will travel through motor more freely.

ckthe fuse and if thats not it ck the wires going to horn and then last it may be a bad horn or its in the steering colum pull the padded area on steering wheel and ck the wire and spring

could be the coolant temp sensor for computer it still may be within its peramiters so it wont turn check engine light on. what i would do is wait till another really cold morning hook up the scanner to your truck if you can get access to one take ambiant temp and campair it to the sensor they should be spot on for temp. and resistance values, good luck

Should be located in the fuse panel under the dashboard.drivers side should say fuse access

1. sound like a bad vacume leak start there first if not fuel pump check put your head bye the back tire and have some on turn the key to the on pos listen for humming sound if no humming a bad pump

sec check for spark pull a spark plug wire off and with a screw driver against the metal turn the key and look for spark try that

might not be getting the spark far enough!

put the van up on ramps in the rear, unbolt gas tanks straps, hopefully u take gas out before, take clamps off filler neck and pull big and small hose off let tank down slow and disconnect wiring plug and fuel lines to pump then pull tank out from under van. very carefully unscrew big washer that holds pump in, put in new pump and reassemble the way you took it out, good luck, remember be gentle with fuel lines and wiring

LIKE WHAT KIND?

97 mazda pickup radio buzzes when engine is turned on

Check your ignition wires. it sounds as though they've gotten wet. they are attached to the spark plugs right behind the front tires. they are accessed through the wheel wells, so actually, if they are
old and becoming that susceptable to moisture, they must be replaced.

Its located on the valve cover....Has a vacuum hose running to it...Should just pop out.

The below diagram applies to your van. Inconsistent response is usually due to a loose connection or worn out switch. Please let me know if you have more questions.

When the airbag light (SRS) is on or blinks it means a fault has occurred in the system and the airbag diagnostic monitor has disabled the system, the most common problem that turns the light on is a break in the connection to the steering wheel mounted airbag, this is due to a rotating ribbon contact that breaks under the steering wheel that connects the airbag to the wiring harness and the diagnostic monitor, the part is called the clock spring contact, a coiled up ribbon electrical contact that turns with the steering wheel while maintaining a mechanical connection to the airgag mounted on the steering wheel, to replace this part you must disarm the airbag system and remove the steering wheel, this requires a special steering wheel puller tool and that you disarm the airbag system before you start the work, to do this disconnect the battery negative cable for 1/2 hour prior.

drain the fule tank drop the tank straps and then pull your lines off there is a tool for this at your auto parts store then un snap fule pump ring pull it out and replace it as a hole unit do not replace it as pices you can mess your fule flote level on the gage up

Hi! It's definitely a headlight relay issue. THe Relay surely is faulty that's why it switches by itself plus the clicking sound indicates that it is faulty. Have it replaced and you'll be good. Hope this helps and thank you for using FixYa!