Top 20
1994 Dodge Caravan - Page 2 Questions & Answers
Rough idlie
check for fuel leaks if there is none then replace the fuel filter if you have not changed it in a long time. check the fuel pressure as if its not in spec then this symptom is a result, and the fuel pump will have to be replaced. if these things are good then you may need to clean the throttle body. this is the area that the throttle cable connects to but the inside section. remove the air box so you can see inside the throttle body and see the throttle valve. using a tooth brush and throttle cleaner, that you can buy at any parts store, and spray the throttle valve and clean it with the brush until there is no more dirt.
Cranks but no spark
Check that all of the wires to the spark plugs are connected right. If that does not work, check that all of the spark plugs are in good condition.
4/21/2014 7:04:37 PM •
1994 Dodge...
•
53 views • 0 helpful votes
Car wont start
Any fuse that is blown may stop it from starting, or no fuse at all if it's something else. Visually inspect the fuses to make sure there is a link. If all the links are good then you need to start looking at other things like fuel pump, timing belt, etc.
Outside sliding door handle is loose
There is 2 small nuts one on each side of the handle. You were correct in pulling the door panel as that is the way you can access them. They are difficult to see but they are there,
12/9/2013 4:07:49 AM •
1994 Dodge...
•
161 views • 0 helpful votes
No spark
Have you checked the auto shutdown relay ?
Diagram on the pcv valve
Its the L shaped plastic sitting in a rubber ring on one of your valve covers connected to Rubber tubing which runs to a throttle body port typically in the front of your carb looking thing. Its part of your vacuum diagram which a image for your specific vehicle is on the hood.
12/8/2013 6:47:09 AM •
1994 Dodge...
•
64 views • 0 helpful votes
96 dodge caravan has drivetrain vibration at
Have the u-joints checked for serviceability. Check rear engine mount is in good condition check that the rear springs are still at the right height. You appear to have a harmonic vibration that is cause by worn u-joints or incorrect drive line operating angles from the angle between the rear of the gear box and the diff pinion having changed . Check the drive shaft for balance as sometimes the balance weight can throw off.
9/29/2013 3:57:09 AM •
1994 Dodge...
•
166 views • 1 helpful votes
Replace motor mounts
You need to replace the Motor Mounts? These are very straight forward...Buy the 3 Mounts (might as well do the Trans mount while you are doing them all... You will notice a difference ImmediatelyUse a floor Jack, take weight slightly off the mount, remove the center bolt on the FORWARD one, then remove the 3 mount Bolts that hold it to the Frame, and reassemble.Do the Top Mount by the Camshaft the same wayTransmission mount is a little harder but you have to get under the car to do this one... Still need the Floor JackBut they are pretty straight forward, nothing Fancy to get it done...Estimated time to do ALL 3..... 50-75 minutes....
98 dodge caravan stalling when breaking
First thing I would check is the easiest fix that I encountered with my only chrysler car. remove the air intake tube at the point where the fuel goes in and the accelerator cable connects. With the car turned off, pull on the cable and you will see a round door type thing. Look to see if there is any black soot around the edges of it. If so, that is the problem, use some carb cleaner and a rag or a green plastic scrubber to clean it off. If you use something metal, you could permanently alter the way your car idles.
3/24/2013 11:09:43 PM •
1994 Dodge...
•
61 views • 0 helpful votes
94 caravan in limp mode sometimes
i have had luck replacing the solenoid packs on these models but i usually had a 12 shift or 23 shift code stored in the tcm controller
12/5/2012 7:12:42 PM •
1994 Dodge...
•
694 views • 0 helpful votes
Not finding what you are looking for?