20 Most Recent
1992 Dodge Spirit Questions & Answers
Turn signals do not work
Under the dashboard should be a fuse panel and some turn signal flashers. All of these are likely under the dash near the driver's knees. Check the fuses first. (Probably not that), then try the turn signal flasher. If your 4-way flasher is working, turn it on and take a flashlight and look up under the dash.This will not be easy. If you can locate the 4-way flasher by the clicking sound it is making, the turn signal flasher should be really near it. They are often side-by-side. If you will take it out, I hope a new one will fix it. Be blessed.
How to oil pan change
Remove Bolts Drop Pan, Clean all serfaces, Apply Gasket sealer /Gasket replace bolts tighten to 23 IN pounds/ Add Recommended Oil,
Run to Check for Leaks, Probably 1 hour will show any leaks if not done Properly
Car will not stay running when you put it in gear.
Look under the hood to see some bare cables that connect the throttle pedal to the throttle body. Turn the idle screw clockwise 1/2 revolution at a time. Start the car, let it warm up and try it. Make sure the rpms aren't above 750 RPM or you'll risk crashing into someone. All this is assuming the car is in good tune, running well, has no major issues etc. These cars were pretty cheap and cheaply made so you may be limited by the age and lack of durability
Why wont my horn work?
Wiring or connectors to horns are bad or disconnected, or most probably, the horns are bad from corrosion.
What causes my car to shut down due to hot outdoor
Could be several things: if the computer is not receiving enough cooling air, it can shutdown to self protect. Another possibility, is the condition called "Vapor lock", where the engine does not receive liquid fuel because of the heat causing it to vaporize, specially if the fuel regulator has problems. Another could be the ignition coil failing when overly hot. ]without more info, it is impossible to know.
Starting problems
Either you installed it wrongly, or the cap is old and the carbon contact inside is too worn; or you inadvertently damaged the distributor wiring exiting from the base of the cap, since old wiring insulation gets hard and brittle.
I need 1992 dodge spirit L4 Head specs.
Get a HAYNES or CHILTON manual. Is has all tghe steps and tightening torque values. The usual tightening sequence is to start at the center bolt, follow with the center one opposite to it, then follow an spiral going out until you reach the last bolt. As usual, you need to do it in three steps, with a decent torque wrench.
Windsheild wiper won't turn off
The electrical mechanism has a rotating arm with a wiper contact, whose objective is to prevent the wipers stopping in the middle of their travel, thus this small wiper contact continues to supply current to the wiper's motor until they reach the end position. From time to time, the wiper (or the electrical track support) rotates out of proper alignment, and just keeps the winshield wipers running. you need to disassemble the motor of the wipers, inside there is a small arm with a contact point, it need to be realigned. It is not difficult, but some dexterity is needed to be able to properly reassemble the motor.
Not finding what you are looking for?