20 Most Recent 1992 Dodge Spirit - Page 3 Questions & Answers

there is a cable going to the hood release latch, sometimes the cable breaks... you can release it by using a screwdriver to push the pawl aside, or you can grab that cable and pull on it manually with a pair of slim pliers.

It is by the battery. The air hose from the air cleaner is hooked to it. Are you sure it needs a computer and not a pick-up in the distributor? Is this a 2.5 or a 3.0?

Click image for zoom ...

Fig. 1: Relay, sensor, harness connector and wiring locations-Spirit, Acclaim and LeBaron sedan models

Additionally, check this wiring diagram that could helpfull...



Fig. 18: Engine control schematic (3.0L)-1992 Spirit, Acclaim, Shadow, Sundance and LeBaron Sedan



Fig. 19: Chassis electrical schematic-1992 Spirit, Acclaim and LeBaron Sedan



Fig. 20: Chassis electrical schematic (continued)-1992 Spirit, Acclaim and LeBaron Sedan

Keep us updated.

could also be a crank sensor or a ignition module as this is a older vehicle it will have a ignition module but where to look first i cannot say as never seen this model here in spain ,also check for a wiring connector somewhere on the vehicle under the bonnet

It is a plastic bushing that holds linkage together you can get replacement bushings from auto parts store like

They can look it up in there books and get the right bushing to put it back together.

195R14

Check fuses and those specific cables.

Wiper Motor and Linkage

Removal and Installation

1. Open hood and remove wiper arms

2. Remove cowl top plastic cover

3. Remove attaching screws or mounting nuts from pivots

4. Disconnect wiper motor wiring harness connector

5. Remove 3 motor mounting bracket-to-body bolts

6. remove motor bracket, motor and linkage assembly from cowl

7. Remove motor-to-bracket mounting bolts and remove motor

8. Reverse procedure to install

It's hooked to the throttle cable. It's roundish plastic disc & can be rotated by hand. Sometimes the cable frays & sticks the throttle open. It could also be caused by a sticking floor mat that has jamed up underneath the accelerator pedal. Try tying the mat to the seat frame to stop it from jamming up.You may have to change the throttle cable however. Hope this helps. Good luck!

Ther is an O ring on the distributor. Remove the distributor bolt & lift out & replace it; however, the leak may be from the rocker cover gasket. Sometimes just a retorquing of the bolts is enough, 7 ft. lbs. is adequate. Hope this helps. Good luck!

turn the key on,off,on,off,on,the check engine light will flash the codes.For instanse code 34 would be 3 flashes,a pause ,then 4 flashes.Will always have a 55 code because the engine is not running.

No Bulbs have a switch

Don't you have the old bulb?

Call the dealers parts dept, to confirm
what parts store said

Replacing the fuel filter is the first thing to do. It also wouldn't hurt to run a good amount of fuel system cleaner through the gas tank. Please rate this answer, thanks.

fuse or starter solenoid